User manual PANASONIC BM-ET500

[. . . ] Iris Camera Operating Instructions Model No. BM-ET500 ACCEPT REJECT READY Before attempting to connect or operate this product, please read these instructions carefully and save this manual for future use. Cautions: · This unit is for indoor use only. · Before attempting to connect or operate this product, please read the label on the bottom. For U. S. A CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. [. . . ] · This product is not designed to prevent theft in advance. We shall not guarantee you for any trouble caused by using this unit. · If you are in a situation that iris recognition is impossible from the exterior, recognition or enrollment will be invalid. Take enough care not to leak the image data out of the administration PC. It is also recommended that you should get an agreement from a person to register his or her data. · We recommend that you note down your settings and save them. Power or battery failure may erase the setting. · Do the self-diagnostic test, when you open this unit door for maintenance, etc. The self-diagnostic test can be carried out by turning on a power supply. Read BM-ED500 Operating instructions for turning on a power supply. 9 MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS q Status indicator ACCEPT REJECT READY w User guidance indicators e Built-in color CCTV camera r Operation indicators t Front panel y 10 key cover u LED indicator 1 6 2 7 3 8 4 9 5 0 CANCEL ENTER o Buzzer-level adjustment hole i Numeric keys q Status Indicator Shows the status of recognition or enrollment. ACCEPT: Lights up when recognition has been successfully executed. * Or lights up when enrollment has been successfully executed through iris image capturing. REJECT: Lights up when recognition has not been successfully executed. Or lights up when enrollment has not been successfully executed through iris image capturing. READY: Lights up when recognition/enrollment is available. When this indicator is blinking, recognition/enrollment is unavailable. * Depending on capturing condition, you might not enroll your iris data even when ACCEPT is lighting. After the enrollment, confirm through the administration PC, in which the administration software is installed, if the recognition has been successfully executed. w User guidance indicators These indicators light up when you stand in front of the unit, and then inform you that recognition/enrollment will start. e Built-in color CCTV camera This is a color camera for surveillance. For example, it is used for status confirmation if a recognition has not been successfully executed. r Operation indicators These indicators show the operation statuses of the unit. The central indicator is lit all the time when power is applied. [. . . ] This unit may be disconnected from the control unit. Remedy Confirm if the power of the control unit is turned on. (Refer to the control unit's operating instructions. ) Refer to the dealer or service personnel. Enrollment/Recognition is invalid. Your iris data, ID, or password may not have been registered. Refer to the system administrator. Your ID or password may be wrong. The front panel may have dust or be damaged. Remove the dust from the front panel. If the panel has been damaged, replace it with a new one. (Refer to p. 15. ) Confirm the connection. [. . . ]