User manual PANASONIC CQ-C1335U

[. . . ] WMA MP3 CD Player/Receiver Model: CQ-C1335U/CQ-C1305U CQ-C1335L/CQ-C1305L Operating Instructions (CQ-C1335U) · Please read these instructions (including "Limited Warranty" and "Customer Services Directory") carefully before using this product and keep this manual for future reference. English Safety Information Read the operating instructions for the unit and all other components of your car audio system carefully before using the system. They contain instructions about how to use the system in a safe and effective manner. Panasonic assumes no responsibility for any problems resulting from failure to observe the instructions given in this manual. This pictograph intends to alert you to the presence of important operating instructions and installation instructions. [. . . ] If such an influence causes distortion to the audio signal, readjust bass/treble or volume. · For further information on Bass, Treble, Balance and Fader settings, refer to Audio Settings. Volume Adjustment (Setting Range: 0 to 40, Default: 18) Turn [VOL]. Mute ON: Press [MUTE]. lights. ) Radio (AM/FM) [SOURCE] (Source) selects a source. [BAND] selects a band in the radio source. [APM] (Auto Preset Memory) executes APM in the radio source. (Hold it down for more than 2 seconds. ) [DISP] (Display) switches the information on the display. [TUNE ] [TUNE ] down/up the frequency. (Hold it down for more than 0. 5 seconds and release it for seek tuning. ) Preset buttons [1] to [6] selects a preset station in the radio source, and presets the current station. (Hold it down for more than 2 seconds. ) 1 Press [SOURCE] to select the radio source. Frequency adjustment 2 Press [BAND] to select a band. [TUNE ]: Lower [TUNE ]: Higher Note: Hold down for 0. 5 sec. or more and release for station search. Operation Flow Preset station selection Press the corresponding preset button from [1] to [6] to tune in a preset station. Band Frequency Preset Number Display change Press [DISP] to change the display. Radio mode display (Default) Radio Source Display lights while receiving an FM stereo signal. Clock display Up to 6 stations can be preset in AM, FM1, FM2, and FM3 respectively. Preset stations can be simply called up by pressing [1] to [6]. Auto Preset Memory (APM) With this operation, stations with good receiving conditions can be automatically stored in the preset memory. Manual station preset Station Preset 1 Select a band. 2 Hold down [BAND] (APM) for more than 2 seconds. The preset stations under best receiving conditions are received for 5 seconds each after presetting the stations (SCAN). To stop scanning, press one of the buttons from [1] to [6]. Note: New stations overwrite existing saved stations. 1 Tune into a station. 2 Hold down one of the preset buttons from [1] to [6] for more than 2 seconds. (blinks once) Note: New stations overwrite existing saved stations. Audio Settings [VOL] selects a value in the audio menu. (PUSH SEL) (Push to select) selects items in the audio menu. [DISP] (Display) exits from the audio menu. to display 1 PressIf[VOL] (PUSH SEL)for more than the audio menu display. seconds in Main volume adjustment), Note: no operation takes place 5 seconds in the audio menu (2 the display returns to the regular mode. Press [VOL] (PUSH 2 mode to be adjusted. SEL) to select a Volume (Setting Range: 0 to 40, Default: 18) 3 Turn [VOL] clockwise or counterclockwise to adjust. : Up : Down Bass (Setting Range: ­12 dB to +12 dB by 2 dB, Default: 0 dB) : Increased : Decreased Audio menu Treble (Setting Range: ­12 dB to +12 dB by 2 dB, Default: 0 dB) : Increased : Decreased Balance (Setting Range: 15 levels each, Default CNT (center)) : Right enhanced : Left enhanced Fader (Setting Range: 15 levels each, Default CNT (center)) : Front enhanced : Rear enhanced Notes: · If the fader is set to front, the pre-amp. · For further information on SQ (Sound Quality) settings, refer to General. · Settings of SQ, bass and treble are influenced one another. If such an influence causes distortion to the audio signal, readjust bass/treble or volume. Player (Disc Player) Disc slot takes a disc in with the printed side facing up. [. . . ] Después de realizar algunas comprobaciones finales, estará preparado para disfrutar de su nuevo sistema estéreo para automóvil. Final Check/Vérifications finales/ Comprobación final 1. Make sure that all wires are properly connected and insulated. Make sure that the main unit is securely held in the mounting collar. Turn on the ignition to check the unit for proper operation. [. . . ]