User manual PANASONIC CQ-DFX338EW

[. . . ] [VOL "]: Decrease the volume by 10 steps. (attenuation) [VOL #]: No sound. Balance and Fader You can adjust the sound balance among the front, rear, right and left speakers. Default: BAL (balance) CNT (center) FAD (fader) CNT (center) Setting range: 15 levels each Select Select Muting or Attenuation You can select MUTE or ATTENUATION when [MUTE] is pressed. Default: MUTE Select 20 CQ-DFX338EW CQ-DFX338EW 21 E N G L I S H 13 Function Settings E N G L I S H 14 1 Press and hold [SEL] 2 Press [SEL] (select). (select) for more than 2 seconds. (Push. ) 3 Turn [VOL]. [#] ["] Security Function Security Function The security indicator blinks when the removable face plate is removed from the unit. [. . . ] Leaving them inside a car for extended periods may damage them and make playback impossible. The unit may not successfully play back a CD-R/RW that was made by the combination of writing software, a CD recorder (CD-R/RW drive) and a disc if they are incompatible one another. This player cannot play the CD-R/RW discs if the session is not closed. This player cannot play the CD-R/RW discs which contains other than CD-DA. Be sure to observe the instructions of CD-R/RW disc for handling it. Notes on CD/CD Media (CD-R, CD-RW) If you use commercial CDs, they must have the label below. E N G L I S H 20 How to hold the disc Do not touch the underside of the disc. When not in use, keep the disc in the case. Label side Do not use irregularly shaped discs. Maintenance Your product is designed and manufactured to ensure a minimum of maintenance. Use a dry, a soft cloth for routine exterior cleaning. Never use benzine, thinner or other solvents. Replacing the Fuse Use fuses of the same specified rating (15 A). Using different substitutes or fuses with higher ratings, or connecting the unit directly without a fuse, could cause fire or damage to the unit. If the replacement fuse fails, contact your nearest Panasonic service station for service. Do not leave discs on the following places: Direct sunlight Near car heaters Dirty, dusty and damp areas Seats and dashboards Disc cleaning Use a dry, soft cloth to wipe from the center outward. nut (5 mm·) Rear support strap Tapping screw (5 mm·a16 mm) Mounting bolt (5 mm·) Power connector Trim plate Lock cancel plate Diagram Q'ty 1 1 1 1 1 1 1 2 If you encounter problems, please consult your nearest professional installer. Caution: This unit operates with a 12 V DC negative ground auto battery system only. Do not attempt to use it in any other system. Before you begin installation, look for the items which are packed with your unit. Panasonic Service Station List for Service Directory . . . Keep for future reference in case the product needs servicing. Installation Hardware. . . Needed for in-dash installation. Turn the ignition on to the accessory position, and ground one lead of the test bulb to the chassis. Touch the other lead of the test bulb to each of the exposed wires from the cut radio connector plug. Touch one wire at a time until you find the outlet that causes the test bulb to light. If the bulb also turns off and on, that outlet is the car power lead. If your car is not wired for an audio unit: Go to the fuse block and find the fuse port for radio (RADIO), accessory (ACC), or ignition (IGN). Battery Lead If your stereo unit has a yellow lead, you will need to locate the car's battery lead. [. . . ] Then close the front panel and press down the right side of the face plate until it clicks into plate. plates 3 1 Insert the lock cancelsides of 8 along the grooves on both the main unit until "click" is heard. 1 Insert. Insert the tab end in the outer groove. Security Indicator The security indicator blinks when the removable face plate is removed from the unit. This function is activated when the security function is on. (page 22) 8 Lock cancel plate Security indicator 2 Pull out the unit while pushing the plates further inside. Panel Removal Alarm This alarm sounds to warn you not to forget to remove the panel before leaving your car. [. . . ]