User manual PANASONIC CQ-DP30EN

[. . . ] PARA REDUCIR EL RIESGO DE INCENDIOS O SACUDIDAS ELÉCTRICAS, Y PARA EVITAR LAS INTERFERENCIAS MOLESTAS, UTILICE SOLAMENTE LOS COMPONENTES INCLUIDOS. Applies only in U. S. A. This equipment has been tested and found to comply with the limits for a Class B digital, Pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in an automobile installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] When the panel is now removed, the security indicator blinks. (Security function) The security function does not work. Pattern 1 Pattern 2 Pattern 3 Pattern 4 Pattern 5 [$] [%] [$] [%] [$] [%] S. A off CQ-DP30EN 46 CQ-DP30EN 47 Troubleshooting Error Display Messages E N G L I S H 33 CD Changer Display Cause/Step Disc is dirty, or is upside down. A disc that has data other than CD-DA or MP3 type is loaded. An attempt was made to play a PAL disc. Cause/Step There is a scratch on the disc. A disc other than a music CD (CD-DA type) is loaded. (The changer automatically switches to the next disc. ) The changer will not operate for some reason. E N G L I S H 34 DVD/Video CD/CD/MP3 Display OSD Playback Error Please eject. Press [<] (eject) on the changer. Eject the disc. This disc may not be played in your region Please eject. 48 CQ-DP30EN CQ-DP30EN 49 Troubleshooting (continued) Common (continued) E N G L I S H 35 DVD/Video CD/CD (continued) Cause/Step A mobile phone is used near the unit. Keep the mobile phone away from the unit. caused by noise) Cause/Step Station is too far, or signals are too weak. Select other stations of higher signal level. Trouble Cause/Step Disc is dirty, or has scratches. Clean disc or change disc, referring to the section on "Notes on Disc". The unit may not successfully play back a CD-R/RW that was made by the combination of writing software, a CD recorder (CD-R/RW drive) and a disc if they are incompatible one another. Refer to instructions for the concerned devices for details. Adjust mounting angle to less than 30x. Mount the unit securely with the mounting parts, referring to the section on installation. Disc is defective. E N G L I S H 36 Trouble Noise. Radio Trouble Too much noise in FM stereo and monaural broadcasts. The motor antenna relay control lead is not connected correctly. [. . . ] 1/4z (5 mm) of protective covering from the ends of the leads before connecting. Do not insert the power connector into the unit until the wiring is completed. Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables and keep cable terminals free from touching any metal parts. [. . . ]