User manual PANASONIC CQ-VX999EW

[. . . ] ¡Si prega di leggere attentamente queste istruzioni prima di usare questo prodotto e di conservare questo manuale per usi futuri. ¡Lea con atención estas instrucciones antes de utilizar el producto y guarde este manual para poderlo consultar en el futuro. Safety Information English Read the operating instructions for the unit and all other components of your car audio system carefully before using the system. They contain instructions about how to use the system in a safe and effective manner. Panasonic assumes no responsibility for any problems resulting from failure to observe the instructions given in this manual. This manual uses pictographs to show you how to use the product safely and to alert you to potential dangers resulting from improper connections and operations. [. . . ] Note: ¡Be sure to set to OFF when you do not use the private mode. ¡It is not possible to choose and set the CS Auto (a page 37) and TIME ALIGNMENT (a page 39) on the sound setting menu while private mode is active. Private mode Private mode Off On Radio Radio DVD Radio DVD Mute 44 CQ-VX999EW Troubleshooting If You Suspect Something Wrong Check and take steps as described below. If the described suggestions do not solve the problem, it is recommended to take the unit to your nearest authorized Panasonic Service Centre. The product should be serviced only by qualified personnel. Please refer checking and repair to professionals. Panasonic shall not be liable for any accidents arising out of neglect of checking the unit or your own repair after your checking. Never take measures especially those other than indicated by italic letters in "Possible Solution" described below because those are too dangerous for users to handle themselves. Warning ¡Do not use the unit in an irregular condition, for example, without sound, or with smoke or a foul smell, which can cause ignition or electric shock. Immediately stop using the unit and consult your dealer. ¡Never try to repair the unit by yourself because it is dangerous to do so. Common Problem Possible cause a Possible solution The power cord (battery, power and ground) is connected in the wrong way. aCheck the wiring. No power to the unit Fuse blows out. aEliminate the cause of fuse blowout and replace the fuse with new one. Preset stations cannot be stored. The MONO mode is active. aCancel the MONO mode. The LOCAL mode is active. The number of receivable stations is less than 6. aMove to an area where receivable stations number is maximum, and try presetting. The contact of the battery lead is poor, or the battery lead is not always powered. aMake sure that the battery lead is connected securely, and preset stations again. RDS PS does not appear even if an RDS station is tuned in to. ("NO PS" appears. ) Receiving programmes differs from PTY that was already set up. "NONE" appears when selecting PTY. The clock time (CT) does not indicate accurately. An AF station cannot be received even if AF indicator lights. A PS code cannot be received for the reason of bad receiving conditions, etc. Wait for a while until conditions change. When the station changed between programmes, the unit could not receive the PTY code. [. . . ] Never take measures especially those other than indicated by italic letters in "Possible Solution" described below because those are too dangerous for users to handle themselves. Warning ¡Do not use the unit in an irregular condition, for example, without sound, or with smoke or a foul smell, which can cause ignition or electric shock. Immediately stop using the unit and consult your dealer. ¡Never try to repair the unit by yourself because it is dangerous to do so. 21 Car Navigation, VCR, Camcorder, Rear View Camera, Rear Monitor Problem The picture from a car navigation system is not displayed. The picture from a VCR or a camcorder is not displayed. [. . . ]