User manual PANASONIC CQ-DFX444

[. . . ] · Pause In principle, CD-R disc play is supported but it does not follow that it will be possible to play all such discs properly. CQ-DFX683U Repeat Play CQ-DF583U Scan Play Press [SCAN]. The first 10 seconds of each track on all discs plays in sequence. E N G L I S H 18 Press [REPEAT]. Repeat the current track. Press [REPEAT] again to cancel. Press [SCAN] again to cancel. 1 CD Changer Mode (When a CD changer is connected and a magazine is in the changer. ) Press [SOURCE] to change to CD changer mode. [. . . ] Adjust balance/fader setting as appropriate. The speaker wires are reversed between right and left. Connect the speaker wires to the correct ones. The model CQ-DFX444 does not support MP3/WMA playback. Error Display Messages CD/MP3/WMA CD CQ-DFX444 Display CQ-DFX683U CQ-DF583U E N G L I S H 28 No sound from left, right, front or rear speaker. Cause/Step Left and right sounds are reversed in stereo listening. Disc is dirty, or is upside down. Check the disc. Remote Control Unit Trouble Battery polarities are reversed. Remote control unit is in the wrong direction. Direct the remote control unit at sensor on the front panel. Check the disc. Buttons are invalid for operation. No operation by some cause. If normal operation is not restored, call the store where you purchased the unit or the nearest Servicenter to ask for repairs. MP3/WMA § The player for some reason cannot read the file you are trying to play. (File recorded in an unsupported file system, compression scheme, data format, file name extension, damaged data, etc. ) Select a file that the player can read. Confirm the type of data recorded on the disc. This player cannot play the CD-R/RW discs if the session is not closed. Hold one lead against one pole of the battery and stroke the other lead across the other pole. You will hear a scraping sound in one of the speakers if you are holding a speaker lead. If not, keep testing different lead combinations until you have located all the speaker leads. When you label them, include the speaker location for each. Antenna Motor If your car is equipped with an automatic power antenna, identify the car motor antenna lead by connecting one bulb tester lead to the car battery lead and touching the remaining exposed wires from the cut radio connector plug one at a time. You will hear the antenna motor activate when you touch the correct wire. Antenna The antenna lead is a thick, black wire with a metal plug at the end. E N G L I S H 32 Installation Hardware No. 1 2 3 4 5 6 7 8 9 Item Mounting collar Hex. nut (5 mm·) Rear support strap Tapping screw (5 mm·a16 mm) Mounting bolt (5 mm·) Power connector Removable face plate case Trim plate Lock cancel plate Diagram Q'ty 1 1 1 1 1 1 1 1 2 Install the unit in the dashboard. If you encounter problems, please consult your nearest professional installer. Caution: This unit operates with a 12 V DC negative ground auto battery system only. [. . . ] Do not expose it to water or excessive moisture. Do not remove the face plate while driving your car. Do not place the face plate on the dashboard or nearby areas where the temperature rises to high level. 2 Pull out. 4 Remove the unit by pulling with both hands. Do not touch the contacts on the face plate or on the main unit, since this may result in poor electrical contacts. If dirt or other foreign substances get on the contacts, wipe them off with a clean and dry cloth. [. . . ]