User manual PANASONIC CSE10KD3EA

[. . . ] ⷠDo not use for other purposes such as preservation of food. ⷠDo not use any combustible equipment in front of the airflow outlet. ⷠDo not expose directly to cold air for a long period. Switch off the power supply before cleaning or servicing. [. . . ] [Information on Disposal in other Countries outside the European Union] These symbols are only valid in the European Union. If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal. Note for the battery symbol (bottom two symbol examples): This symbol might be used in combination with a chemical symbol. In this case it complies with the requirement set by the Directive for the chemical involved. Do not switch ON the unit when waxing the floor. After waxing, aerate the room properly before operating the unit. ⷠDo not install the unit in oily and smoky areas. Use this air conditioner under the following temperature range (CU-E10HBEA) Temperature (°C) COOLING HEATING Maximum Minimum Maximum Minimum Indoor *DBT 32 16 30 16 *WBT 23 11 *DBT 43 -10 24 -10 Outdoor *WBT 26 18 - This unit is still able to operate as a cooler with outdoor temperature as low as -10°C in a non-living room, such as a computer room, with a room temperature of 16°C or above, and room humidity up to 80%. When the outdoor temperature drops to -10°C, compressor will be cut off and resume operation again once the temperature rises to more than -10°C. ⷠWhen the outdoor temperature is out of the above temperature range, the heating capacity will drop significantly and outdoor unit might stop for protection control. The operation mode priority is given to the first unit that turned on. ⷠDuring operation, heating and cooling mode could not be activated at the same time for different indoor unit. ⷠThe power indicator blinks to indicate the indoor unit is standing by for different operation mode. Open the cover to use the buttons Please be aware of the OFF indication on the remote control display to prevent the unit from starting/stopping improperly. ⷠFor normal operation, OFF indicator shown on remote control display when the unit is turn off. To turn ON or OFF the unit at a preset time. Press once to change the display from Clock to Timer or vice-versa. ⷠPress for more than 4 seconds to change the display from Daily Timer to Weekly Timer or viceversa. Unit selects operation mode according to temperature setting, outdoor and room temperature. hEAT mode - To enjoy warm air · Unit takes a while to warm up. [. . . ] ⷠTurn off the power supply. NON SERVICEABLE CRITERIAS TURN OFF POWER SUPPLY then please consult authorized dealer under the following conditions: · The following symptoms do not indicate malfunction. This may due to damp smell emitted by the wall, carpet, furniture or clothing. Indoor fan stops occasionally during automatic · Operation is delayed a few minutes after · Power indicator blinks during operation and · The unit is in defrost mode, and the melted frost is drained from the the indoor fan is stopped. [. . . ]