User manual PANASONIC CS-E7JKEW

[. . . ] ⷠDo not use any combustible equipment in front of the airflow outlet. ⷠDo not expose directly to cold air for a long period. Switch off the power supply and unplug before cleaning or servicing. ⷠTurn off the power supply and unplug if the unit is not used for a long period of time. [. . . ] ⷠThis equipment must be earthed and strongly recommended to be installed with Earth Leakage Circuit Breaker (ELCB) or Residual Current Device (RCD). Otherwise, it may cause electrical shock or fire in case of malfunction. ⷠIn case of emergency or abnormal conditions (burnt smell, etc), turn off the power supply and unplug, and consult your nearest dealer. Do not insert your fingers or other objects into the unit. The appliance is not intended for use by young children or the infirm person without supervision. Young children should be supervised to ensure that they do not play with the appliance. Use this air conditioner under the following temperature range Temperature (°C) Indoor *DBT *WBT 32 23 16 11 30 16 Outdoor *DBT *WBT 43 26 -15 24 18 -10 - This unit is still able to operate as a cooler with outdoor temperature as low as -15°C in a non-living room, such as a computer room, with a room temperature of 16°C or above, and room humidity up to 80%. When the outdoor temperature drops to -15°C, compressor will be cut off and resume operation again once the temperature rises to more than -15°C. ⷠWhen the outdoor temperature is out of the above temperature range, the heating capacity will drop significantly and outdoor unit might stop for protection control. Replacement or installation of power plugs shall be performed by authorized/ qualified personnel only. The wires in this mains lead are coloured in accordance with the following code: NOTE : The illustrations in this manual are for explanation purposes only and may differ from the actual unit. During operation mode selection the power indicator blinks. hEAT mode - To enjoy warm air · Unit takes a while to warm up. The power indicator blinks during this operation. cOOL mode - To enjoy cool air DRY mode - To dehumidify the environment · Unit operates at low fan speed to give a gentle cooling operation. To turn ON or OFF the unit at a preset time. For AUTO, the indoor fan speed is automatically adjusted according to the operation mode. In heat mode, the air blows horizontally for a while, then starts to blow downwards and the airflow louvers start to swing left/right after the temperature rises. When ON Timer is set, the unit may start earlier (up to 30 minutes) before the actual set time in order to achieve the desired temperature on time. If timer is cancelled manually or due to power failure, you can restore the previous setting (once power is SET resumed) by pressing . Supersonic air purifying device (super alleru-buster) operates automatically once the unit is switched on. ⷠ, and can be activated in all modes and can be cancelled by pressing the respective button again. [. . . ] ⷠIt is recommended to clean the filter every 6 months. ⷠReplace the filter every 3 years or replace any damaged filter. After 15 minutes of operation, it is normal to have the following temperature difference between air inlet and air outlet vents: Cooling: 8°C Heating: 14°C TURN OFF POWER SUPPLY AND UNPLUG then CALL Authorized Distributor under the following conditions: · Activate heat mode for 2~3 hours to thoroughly dry the unit. ⷠTurn off the power supply and unplug. [. . . ]