User manual PANASONIC CS-QE12PKE

[. . . ] Before operating the unit, read these operating instructions thoroughly and keep them for future reference. 42-51 F569237 Dansk Suomi Norsk Svenska English Provide maximum comfort, clean air and optimise energy saving ECONAVI The sunlight sensor detects the sunlight intensity and helps control heating/cooling temperatures to provide optimum comfort. It also deactivates viruses and bacteria on the filter to keep inside of the unit clean. 2 Quick guide Table of contents Inserting the batteries 1 3 2 1 Pull out the back cover of remote control 2 Insert AAA or R03 batteries (can be used ~ 1 year) 3 Close the cover 2 TIMER ON 1 2 SET 3 Safety precautions . [. . . ] OFF CANCEL AC RC SET CHECK CLOCK RESET To switch between powerful & quiet QUIET NORMAL FAN SPEED POWERFUL To select fan speed POWERFUL: To reach temperature quickly POWERFUL (Remote control display) • This operation stops automatically after 20 minutes. qUIET: To enjoy quiet operation QUIET • This operation reduces airflow noise. € For AUTO, the indoor fan speed is automatically adjusted according to the operation mode. € In HEAT mode, if manual fan speed caused discomfort, set the fan speed to AUTO or lower the fan speed. Press the button once to use in AUTO mode. Press and hold the button until you hear 1 beep, then release to use in forced COOL mode. Press and hold the button until you hear 2 beeps, then release to use in normal COOL mode. Press and hold the button until you hear 3 beeps, then release to use in forced HEAT mode. NANOE-G To purify the air To set the timer 2 sets of ON and OFF timers are available to turn ON or OFF the unit at different preset times. 1 TIMER ON 1 2 NANOE-G • Can be activated even when the unit is turned off. In this condition, the unit will operate as a fan with AUTO fan speed and louver swing. 2 3 SET To deactivate viruses/bacteria on the filter NANOE-G POWER 2 Set the time 2 AIR SWING To adjust vertical airflow direction 3 Confirm SET (Remote control display) TIMER • To cancel ON or OFF timer, press or OFF to select respective or then press CANCEL. € If timer is cancelled manually or due to power failure, you can restore the timer again by ON or OFF to select respective or pressing SET then press . • The nearest timer setting will be displayed and will activate in sequence. € When ON Timer is set, the unit may start earlier (up to 35 minutes) before the actual set time in order to achieve the desired temperature on time. € Timer operation is based on the clock set in the remote control and repeats daily once set. € In HEAT mode, if AUTO is set, the horizontal louver is fixed at the predetermined position. note To adjust horizontal airflow direction • Manually adjustable. ECONAVI POWERFUL/ QUIET NANOE-G , , • Can be activated in all modes and can be cancelled by pressing the respective button again. eCONAVI POWERFUL/ QUIET , • Cannot be selected at the same time. English • After the unit is turned off, the nanoe-G in-filter deactivation may activate up to 150 minutes. Turning on the unit cancels this operation. [. . . ] For business users in the European Union If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information. [Information on Disposal in other Countries outside the European Union] These symbols are only valid in the European Union. If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal. Note for the battery symbol (bottom two symbol examples): This symbol might be used in combination with a chemical symbol. [. . . ]