User manual PANASONIC CS-UW12GKE

[. . . ] ⷠRemove the batteries if the unit is not going to be used for a long period of time. ⷠNew batteries of the same type must be inserted following the polarity stated to prevent malfunction of the remote control. Do not install the unit in a potentially explosive atmosphere. Do not wash the unit with water, benzene, thinner or scouring powder. [. . . ] If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal. Pb Note for the battery symbol (bottom two symbol examples): This symbol might be used in combination with a chemical symbol. In this case it complies with the requirement set by the Directive for the chemical involved. Use this air conditioner under the following temperature range. This model is not suitable for 4 hours non-stopping operation in heating mode below -5°C. When the outdoor temperature is below -5°C and you use this model out of above conditions, the outdoor unit might be frozen up and stop operation for protection control. Replacement or installation of power plugs shall be performed by authorized/ qualified personnel only. The wires in this mains lead are coloured in accordance with the following code: The illustrations in this manual are for explanation purposes only and may differ from the actual unit. It is subjected to change without notice for future improvement. Wiring colour may vary depending on a country wiring code's standard. The appliance is not intended for use by young children or the infirm person without supervision. Young children should be supervised to ensure that they do not play with the appliance. ⷠCertain fluorescent lights may interfere with signal transmission. The retention period of batteries might be affected to be shorter because of the using times of the remote control, even less than one year. Unit selects the operation mode according to the room temperature. ⷠOnce auto mode is selected, the unit will operate at the standard setting temperature. Room temperature 23°C & above Below 23°C Below 20°C Operation mode Cool Dry Heat Standard setting temperature (+2°C) 25°C 27°C 22°C 24°C 21°C 23°C (­2°C) 23°C 20°C 19°C In heat mode, it takes a while for the unit to warm up. The power indicator blinks during this operation. During soft dry operation, the indoor fan operates at low fan speed to give a very gentle cooling operation. Forheat, coolanddrymodes, therangeof temperature can be selected from 16°C ~ 30°C. [. . . ] Operation will be restarted automatically under the previous operation mode and airflow direction when power is resumed as the operation is not stopped by remote control . to cancel the Auto Restart Control , please refer to page 6. The unit is in defrost mode, and the melted frost is drained from the outdoor unit. Power indicator blinks during operation and the indoor fan is stopped. [. . . ]