User manual PANASONIC CY-VMD9000U

[. . . ] E N G L I S H 47 Installation Guide WARNING This installation information is designed for experienced installers and is not intended for non-technical individuals. It does not contain warnings or cautions of potential dangers involved in attempting to install this product. Any attempt to install this product in a motor car by anyone other than qualified installer could cause damage to the electrical system and could result in serious personal injury or death. Before you begin installation, look for the following items which are packed with your unit. Warranty Card. . . Fill this out promptly. [. . . ] Video control lead To the video control lead of the Panasonic car navigation system (not available yet). Side brake (parking brake) connection lead Be sure to wire the side brake (parking brake) for safety and preventing accidents. ( page 78) Reverse lead When connecting the rear view camera, use the reverse lead. ( page 79) Use a reverse extension cord A if needed. (Resistor 220 ) Power lead To ACC power, _12 V DC. ACC 220 VIDEO-CONT Control unit (rear) @ Power connector (Black) REMOTE-OUT (Green/yellow stripe) SIDE BRAKE (Blue/yellow stripe) REVERSE Remote control signal receiver cord To the REMOTE-IN terminal of the Panasonic DVD video player (CX-DV700U). Use this cord when connected to CX-DV700U. (Black) SPEAKER Connector Connect AV control unit with receiver (CA-TU7000U) or multi channel AV control unit with receiver (CA-TU9000U). (Black) Leave the cover unremoved if you do not connect AV control unit with receiver (CA-TU7000U) or multi channel AV control unit with receiver (CA-TU9000U). (Violet/white stripe) Control unit (front) Panasonic + - VTR1-IN VTR2-IN Speaker lead (Black/green stripe) (Black/green stripe) Supplied speaker VIDEO-OUT Cannot be used for a center speaker. Video output terminal Connect the second monitor. ( page 77) Video input terminal 2 (VTR2-IN) Connect a VCR, camcorder, rear view camera, other brand's navigation system, and so on. ( pages 77, 79) Video input terminal 1 (VTR1-IN) Connect a VCR, camcorder, rear view camera, other brand's car navigation system, and so on. ( pages 77, 79) CY-VMD9000U (Red) (Fuse 5 A) Battery lead To the car battery, continuous _12 V DC. BATTERY 5 A R (Red) PRE-OUT 5A Pre-out cord (Yellow) To the input terminat of the auxiliary system. L (White) Ground lead To a clean, bare metallic part of the car chassis. (Black) 70 CY-VMD9000U 71 E N G L I S H 57 Electrical Connections (Continued) Connection with Multi Channel AV Control Unit with Receiver (CA-TU9000U) Notes: Refer to the operating instructions for the connected devices, in addition. Refer to the operating instructions for the CA-TU9000U. E N G L I S H 58 CY-VMD9000U Display unit (rear) @ Power connector R (Red) Pre-out cord PRE-OUT No audio is output from the pre-out cord when connecting to CA-TU9000U. L (White) Optical fiber cable (sold separately, CA-LRD60) Notes on handling optical fiber cable: · Do not bend the cable sharply. · Do not allow the cable to be damaged by getting it caught in the door, placing a heavy object on it, etc. (Red) (Red) CA-TU9000U Multi channel AV control unit with receiver (front) CY-VMD9000U Control unit CA-TU9000U Multi channel AV control unit with receiver (rear) CY-VMD9000U Control unit To subwoofer + RCA cord (optional) Center speaker extension cord (supplied to CA-TU9000U) CENTER Power amplifier (Black) CENTER To center speaker + (Black) (Black/green stripe) (Green) (Black/green stripe) (Left) - Rear speaker cord (left) REAR L Center speaker cord (supplied to CA-TU9000U) (Green/black stripe) (Violet) To rear speaker + Rear speaker cord (right) REAR R (Right) + (Violet/black stripe) (White) Power connector (supplied to CA-TU9000U) FRONT L Front speaker cord (left) (Left) - (White/black stripe) (Gray) To front speaker + Front speaker cord (right) FRONT R C Display unit/control unit connecting cord (Right) - (Gray/black stripe) 72 CY-VMD9000U CY-VMD9000U 73 E N G L I S H 59 Electrical Connections (Continued) Connection with AV Control Unit with Receiver (CA-TU7000U) Notes: Refer to the operating instructions for the connected devices, in addition. Refer to the operating instructions for the CA-TU7000U. E N G L I S H 60 CY-VMD9000U Display unit (rear) Digital surround processor CY-AC300 Operating unit CE SOUR AC300 Operating unit/main unit connecting cord (supplied to CY-AC300) DIGITAL OUND SURR DIGITAL ESSOR PROC PRO LOGIC VOL super bright multi-colo r displ powe ay & 30W r ampl ifier for center speaker POSITION SPAC E DIMMER DIM E MUT 1 2 3 4 P POSI DR COM SPC CY-AC300 Main unit (rear) @ Power connector R (Red) S PWR CY-AC300 Main unit (front) L L L R R SUB · W REAR FRONT ANALOG-IN R Pre-out cord PRE-OUT E L No audio is output from the pre-out cord when connecting to CA-TU7000U. L (White) Power connector (supplied to CY-AC300) POWER SUPPLY CONTROL UNIT (L) (R) (L) (R) (L) (R) Optical fiber cable (sold separately, CA-LRD60) Notes on handling optical fiber cable: · Do not bend the cable sharply. · Do not allow the cable to be damaged by getting it caught in the door, placing a heavy object on it, etc. CY-VMD9000U Control unit Pre-out (Front) MAIN-IN (Rear) MAIN-IN (Front) RCA cord (optional) + To center speaker - (Black) (Black/green stripe) (Red) Center speaker cord CENTER CA-TU7000U AV control unit with receiver (front) CA-TU7000U AV control unit with receiver (rear) CY-VMD9000U Control unit To subwoofer + RCA cord (optional) Power amplifier (Green) (Left) - Rear speaker cord (left) REAR L (R) (L) (R) (L) (R) (L) (Green/black stripe) (Violet) To rear speaker + Rear speaker cord (right) REAR R (Right) + (Violet/black stripe) Power connector (supplied to CA-TU7000U) (White) Front speaker cord (left) FRONT L (Left) - (White/black stripe) (Gray) To front speaker + Front speaker cord (right) FRONT R C Display unit/control unit connecting cord (Right) - (Gray/black stripe) 74 CY-VMD9000U CY-VMD9000U 75 E N G L I S H 61 Electrical Connections (Continued) Connection with CD Changer (CX-DP88U) Note: Refer to the operating instructions for the connected devices, in addition. Ground lead (Black) CD Changer (CX-DP88U) Connection with VCR or Camcorder Note: Refer to the operating instructions for the connected devices, in addition. E N G L I S H 62 CY-VMD9000U Control unit (front) Video output Audio Left Right Power connector (supplied to CX-DP88U) RCA cord (R) (Red) R (Red) Video (Yellow) VCR L (White) Camcorder Video (Yellow) L (White) R (Red) CY-VMD9000U Control unit (front) (L) (White) CD changer control connector Battery lead (Yellow) BATTERY RCA cord (optional) (Fuse 3 A) DIN cord CA-TU7000U AV control unit with receiver CA-TU7000U (front) or CA-TU9000U Multi channel AV control unit CY-VMD9000U with receiver Connection with Rear Monitor Note: Refer to the operating instructions for the connected devices, in addition. CY-VMD9000U Control unit (front) Control unit (rear) Power connector (supplied to CA-TU7000U/ 9000U) CA-TU7000U (rear) Video (Yellow) Rear monitor (CY-VM5800U) VTR-IN VT R-I N RCA cord (optional) 76 CY-VMD9000U CY-VMD9000U 77 E N G L I S H 63 Electrical Connections (Continued) Connecting the Side Brake (Parking Brake) Connection Lead Caution: For safety, be sure to ask your nearest professional installer to do this connection. Connection with Rear View Camera Note: Refer to the operating instructions for the connected devices, in addition. E N G L I S H 64 CY-VMD9000U Display unit (rear) Side brake (parking brake) switch Rear view camera control unit Camera input Video output Side brake (parking brake) Foot brake Rear view camera Panasonic Video (Yellow) @ Power connector The side brake (parking brake) switch position varies with the car model. For details on the exact location of the side brake (parking brake) switch in your car, contact your dealer. Side brake (parking brake) connection lead (Blue/yellow stripe) SIDE BRAKE CY-VMD9000U Control unit (front) RCA cord (optional) Brake light Battery Video (Yellow) B Clip connector When the side brake (parking brake) lever is engaged, the unit is grounded by the chassis. Check the reverse lamp. Car chassis Connecting the Reverse Lead In case using an optional rear view camera, the reverse lead must be connected. Connect the reverse lead (violet/white stripe) to the positive (_) lead of the reverse lamp (the lamp with a clear lens that lights when the transmission gear is shifted into the reverse position). Notes: Connect the reverse lead after cutting the terminal at the end. [. . . ] 5, 451, 942 and other world-wide patents issues and pending. "DTS" and "DTS Digital Surround" are trademarks of Digital Theater Systems, Inc. Title, Chapter (DVD) DVDs are divided into some large sections (titles) or some small sections (chapters). Each section is numbered; these numbers are called "Title number" or "Chapter number". [. . . ]