User manual PANASONIC CZKPU3A

[. . . ] Specifications Operating Instructions Panel for Cassette (ECONAVI type) Model Name Unit Dimensions Net Weight Temperature / Humidity Range Power Source CZ-KPU3A (Width) 950mm × (Depth) 950mm × (High) 33. 5mm 5 kg 0°C to 40°C / 20% to 80% (Indoor use only) DC16 V (Supplied from indoor unit) Precautions for Use Installation  This optional of must be installed properly by qualified installation technicians in accordance with the Installation Instructions provided with the unit. Information for Users on Collection and Disposal of Old Equipment and Used Batteries These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste. For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection points, in accordance with your national legislation and the Directives 2002/96/EC and 2006/66/EC. By disposing of these products and batteries correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. [. . . ] Use this only for its intended purpose as described in these Operating Instructions. Detection area of Floor Temperature Sensor Sample of remote control display (CZ-RTC5A) when setting the ECONAVI function: is displayed when setting the ECONAVI function. (In case of sensor error, is displayed in the same position. See the Section “Troubleshooting” on page 15. ) NOTE ● The further human is away from the Human Detection Sensor, the larger the movement of human body is required to be detected. ● A place where the blind angle of the Human Detection Sensor cannot detect human. ● When operating the multiple indoor units, the effect of energy saving will be decreased according to the room condition. ● As for the setting method of the ECONAVI function, refer to the Operating Instructions of the remote controller. When taking advantage of the external device interlock function, one of the output of Human Detection Sensor, output of thermostat ON or output of operation signal can be selected and it is possible to interlock with the external device. Maintenance Indoor Unit (e. g. Type U2) If the human detection sensor or floor temperature sensor becomes dirty, wipe off with a dry soft cloth. In case of heavy dirt, mix a tiny amount of neutral detergent with water and soak it into a soft cloth, squeeze well and gently wipe off the dirt. Then, wipe with a soft dry cloth. In case of more physical human activity  Contents of Control ● Interlock with the output of Human Detection Sensor output (No interlock with the alarm. ) Human presence → When human absence detected: Set the operation of external device to OFF. The time change of "Absence detection time setting" can change timing of operation OFF. Human absence → When human presence detected: Set the operation of external device to ON. ● Interlock with human detection sensor output (Interlock with air conditioner. ) When the indoor unit is operated: Operation of external device is switched ON. When the indoor unit is stopped: Operation of external device is switched OFF. ● Interlock with thermostat output When the thermostat is switched ON: Operation of external device is switched ON. When the thermostat is switched OFF: Operation of external device is switched OFF. WARNING  For safety, be sure to turn the air conditioner off and disconnect the power before cleaning. (Otherwise, electric shock or injury may result because the fan is rotating at high speed. )  Do not pour water on the indoor unit. (This may damage the internal components and cause an electric shock hazard. ) • In Cooling / Dry Mode: When in high humid, operates at set temperature. When in low humid, operates at higher temperature than the set temperature. Operates at lower temperature than the set temperature. • In Heating Mode: In case of less physical human activity Air outlet Air intake CAUTION  Never use solvents or harsh chemicals. Also, do not wipe plastic parts using very hot water. (This may cause deformation or change in colour. )  Some metal edges and fins are sharp. (Injury may result. )  Use a firm stool or ladder when cleaning an indoor unit installed in high locations. [. . . ] → Set to the operation mode temporarily excepting air flow and check the display. → Set the ECONAVI function to ON by the remote controller. → If no content of ECONAVI function is described in the Operating Instructions of remote controller, the remote controller is not provided with the ECONAVI function. → If the symptom does not change even after remote control operation, the indoor unit is not provided with the ECONAVI function. [. . . ]