User manual PANASONIC DMW-MCTZ5

[. . . ] -If you see this symbolInformation on Disposal for Users of Waste Electrical & Electronic Equipment (private households) This symbol on the products and/or accompanying documents means that used electrical and electronic products should not be mixed with general household waste. For proper treatment, recovery and recycling, please take these products to designated collection points, where they will be accepted on a free of charge basis. Alternatively, in some countries you may be able to return your products to your local retailer upon the purchase of an equivalent new product. Disposing of this product correctly will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. [. . . ] The unit fires at the guide number (GN)¢ which has been set. Turn on the power of the digital camera. If the ISO sensitivity is [100], the optimum camera to subject distance can be calculated by dividing the guide number (GN) by the aperture. Turn the [GN/ISO] dial and set the guide number (GN) so that the camera to subject distance is set to the distance the subject. The [F] dial can also be used for this setting. If the optimum camera to subject distance is closer than 0. In this case, the user is warned by the flashing of the number on the display. The optimum camera to subject distance changes depending on the digital camera settings (ISO sensitivity, aperture, focal length and shutter speed). Push the shutter button all the way down, and take the photo. The flash working range is shown on the display panel in line with the settings of the digital camera. If the [AUTO CHECK] lamp continues to flash for about 5 seconds, it means that the unit has fired successfully. Push the shutter button all the way down, and take the photo. check that the [AUTO CHECK] lamp is flashing. If the [AUTO CHECK] lamp continues to flash for about 5 seconds, it means that the unit has fired successfully. If the combination of the ISO sensitivity and aperture are outside the usable range, a warning is given in the form of the flashing ISO sensitivity and aperture displays. Working range when taking pictures in [AUTO] (m) The areas framed by the bold lines indicate the flash working range when the wide panel is used. (P26) When the flash head is facing toward the front, the number displayed at the near-distance side is 0. 6 m or more, and when it is pointed downward, it is 0. The flash intensity can be adjusted in 1/3 steps by varying the ISO sensitivity and aperture from the digital camera settings. (P20) The guide number (GN) and light quantity ratio appear on the display panel. Push the shutter button all the way down, and take the photo. When the camera to subject distance and aperture have been decided upon The following formula is used to obtain the guide number (GN), which is then set in the unit. [. . . ] Wipe away dust and fingerprints using a soft, dry cloth. Do not use kitchen detergents or chemical cleaning cloths. If rain or drops of water splash onto the unit, wipe off the water with a dry cloth. Do not carry the unit when it is still attached to the camera body. [. . . ]