User manual PANASONIC DMWXLR1E

[. . . ] Please read these instructions carefully before using this product, and save this manual for future use. FCC Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] For proper treatment, recovery and recycling of old products, please take them to applicable collection points in accordance with your national legislation. • Use a shielded XLR microphone cable with a XLR (3 pin) terminal. €¢ The microphone cable can be attached to the unit’s cable holder. 1 Slide the lock lever in the direction opposite to that indicated by the [LOCK 1] icon (1). Microphone adaptor into the hot shoe until it clicks securely into place (2). π± 2 Slide the XLR  3 Slide the lock lever to the  • The orientation of the cable holder can be changed. Remove the cable holder and attach it in a different orientation. €¢ Keep the cable holder out of reach of children to prevent swallowing. €¢ To remove the XLR microphone adaptor, slide the lock lever in the direction opposite to the [LOCK 1] arrow and slide it from the hot shoe. 6 DVQX1208 (ENG) DMW-XLR1PP&E&GK-DVQX1208ZA. Book 7 ページ ２０１７年２月６日　月曜日　午後５時１１分 • A commercially available XLR microphone or microphone holder can be attached to the unit’s accessory shoe. Book 9 ページ ２０１７年２月６日　月曜日　午後５時１１分 Cautions for Use ∫ About the unit Do not use this unit near radio transmitters or highvoltage lines. €¢ Noise may be present in images and sound recorded near radio transmitters or high-voltage lines. perform recording in locations away from them. The level of noise varies depending on the XLR microphone used. Keep the unit away from insecticide sprays and other volatile substances. €¢ Exposure to such substances may cause damage to the external case and the text and symbols printed on the unit. €¢ Do not leave the unit in contact with any items made of rubber or PVC for prolonged periods of time. Do not carry the unit with your hands while it is still attached to a digital camera. €¢ Under no circumstances should the unit be used or stored in any of the following locations since doing so may cause trouble in operation or malfunctioning: – In direct sunlight or on a beach in summer – In locations with high temperatures and humidity levels or where changes in temperature and humidity are acute – In locations with high concentrations of sand, dust or dirt – Where there is fire – Near heaters, air conditioners or humidifiers – Where water may make the unit wet – Where there is vibration – Inside a vehicle • Do not drop the unit, knock it into other objects or subject it to any other kind of strong impact or shock. €¢ When recording a motion picture, the digital camera or lens sounds or other operating noise may be recorded. If the sound from the lens is particularly bothering, set the camera to manual focus during use. [. . . ] €¢ When using a chemical cloth, be sure to follow the accompanying instructions. (ENG) DVQX1208 9 DMW-XLR1PP&E&GK-DVQX1208ZA. Book 10 ページ ２０１７年２月６日　月曜日　午後５時１１分 Specifications Specifications are subject to change without notice. Input terminal Standard input level Standard recording level Frequency characteristic GAIN switch LOW CUT switch Dimensions INPUT1 terminal, INPUT2 terminal: XLR3-pin, female LINE: 0 dBu MIC, _48V: j40 dBu (0 dBu=0. [. . . ]