User manual PANASONIC EY3793

[. . . ] By sliding the mode selector switch, soft impact mode or hard impact mode can be selected. Soft impact mode has lower torque setting and help avoiding the damage of material caused by over-tightening power. It is recommended to select this mode to minimize the damage of small size screw head or the damage of the soft material surface to be fastened by controlling the trigger switch. (J) (K) S (A) Nose protector (B) 6. 35 mm(1/4") hex quick connect chuck (C) LED light (D) Variable speed control trigger (E) Impact mode selector switch (F) Bit holder (inside of the body) (G) Forward/Reverse lever (H) Belt hook lock lever ( I ) Belt hook (J) Battery pack release button (K) Battery pack (EY9201) (L) Battery charger (EY0110) ­6­ S: 80 Nm, (820kgf-cm, 711in-lbs) soft impact mode 0 - 2200 RPM Impact mode Maximum torque Maximum R. P. M. H H S S : Soft impact mode H : Hard impact mode Recommended application small size screw, soft material, thin metal stud H: 120 Nm, (1220kgf-cm, 1060in-lbs) long size screw hard impact mode 0 - 2600 RPM bolts/nut ­7­ LED light CAUTION: The built-in LED light is designed to illuminate the small work area temporarily. [. . . ] Do not use it as a substitute for a regular flashlight, since it does not have enough brightness. Forward Reverse Depress the trigger switch, then LED light turns on. When the trigger switch is released, the light turns off automatically. The light illuminates with very low current, and it does not adversely affect the performance of the driver during use or its battery capacity. How to use the belt hook WARNING: · Be sure to attach the belt hook securely to the main unit with the screw firmly fastened. When the belt hook is not firmly attached to the main unit, the hook may depart and the main unit may fall. This may result in an accident or injury. · Be sure to attach the belt hook firmly and securely onto a waist belt or other belt. To secure the lock, follow 3 and 4 above. Switch lock CAUTION: To prevent damage, do not operate Forward/Reverse lever until the bit comes to a complete stop. To change the belt hook location side The belt hook can be attached to either side of the unit. To set the belt hook angle position 1. Slide the belt hook lock lever # and hold it to unlock the belt hook 1. Loosen the screw turning it counterclock-wise, using a coin or a flat blade screw driver $ # 3. Take out the belt hook and insert into the other side of the slot on the main unit storing position CAUTION To eliminate excessive temperature increase of the tool surface, do not operate the tool continuously (using two or more battery packs consecutively. ) Tool needs cool off time before switching to another pack. 2. Pull the belt hook from storing position $ and set it as desired angle 4. Fasten the screw firmly, turning it clockwise The belt hook can be taken out from the main unit only when it is at storing position. ­8­ ­9­ 1 · If a fully charged battery pack is inserted into the charger again, the charging lamp lights up. After several minutes, the charging lamp may flash quickly to indicate the charging is completed. Battery pack CAUTION: To prevent the risk of fire or damage to the battery charger. [. . . ] Fasten the screw firmly, turning it clockwise The belt hook can be taken out from the main unit only when it is at storing position. ­8­ ­9­ 1 · If a fully charged battery pack is inserted into the charger again, the charging lamp lights up. After several minutes, the charging lamp may flash quickly to indicate the charging is completed. Battery pack CAUTION: To prevent the risk of fire or damage to the battery charger. · Do not use power source from an engine generator. [. . . ]