User manual PANASONIC EY6220D

[. . . ] Select the suitable bit and lightly push it into the hexagonal driving shaft of the main unit. (Refer figure 2) E Refer figure 2 for useable bits. 1) Be aware that this tool is always in an operating condition, since it does not have to be plugged into an electrical outlet. Hold the tool only by the plastic handle to prevent electric shock in case you drill into a "live" wire. [. . . ] CAUTION: Exact torque should be verified with a torque wrench for precise limits as the screw can be damaged. Push the upper half of the switch for forward ( ) rotation, or the lower half for reverse ( ) rotation. NOTE: When you charge the battery pack for the first time, or after prolonged storage, charge it for about 24 hours to bring the batteries up to full capacity. Press the battery pack release button and pull the pack away from the tool. Insert the battery pack firmly into the charger. During charging, the charging lamp will be light up. If the charging lamp does not light, check to determine whether the contacts are clean and the battery pack is inserted completely. Avoid charging at temperatures below 0°C above 40°C. After charging has been completed, remove the battery pack from the charger and reinsert it into the tool. If the charging lamp does not turn on immediately afater the chager has been plugged in, or if after 2 hours of charging the lamp does not go off, consult an authorized dealer for checking. NOTE: The battery pack EY9021 can be charged by 15 min. Do not use power source from an engine generator. To suit the application of this tool, two different rotational speeds are available. Depending upon use, either the high or low speed should be selected. LOW HIGH 200min-1 (RPM) 400min-1 (RPM) strong torque less torque CAUTION: Check rotational speed selection before operating this tool. After use, set the main switch lock at the lock position to prevent accidental operation. Press the battery pack release buttons on both sides and pull the pack away from the tool. After the charging has been completed, remove the battery pack from the charger and connect it to the tool. [. . . ] IMPORTANT: The wires in this mains lead Are coloured in accordance with the following code: Blue: Neutral Brown: Live As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. The wire which is coloured BLUE must be connected to the terminal in the plug which is marked with the letter N or coloured BLACK. The wire which is coloured BROWN must be connected to the terminal in the plug which is marked with the letter L or coloured RED. Under no circumstances should either of these wires be connected to the earth terminal of the three pin plug, marked with the letter E or the Earth Symbol L . [. . . ]