User manual PANASONIC HFS12060E

[. . . ] € This could cause the lens to collect an excessive amount of light, resulting in fire and malfunction. € Under no circumstances should the unit be stored in any of the following locations since doing so may cause problems in operation or malfunctioning. € In direct sunlight or on a beach in summer – In locations with high temperatures and humidity levels or where the changes in temperature and humidity are acute – In locations with high concentrations of sand, dust or dirt – Where there is fire – Near heaters, air conditioners or humidifiers – Where water may make the unit wet – Where there is vibration – Inside a vehicle • Refer also to the operating instructions of the digital camera. € When the unit is not going to be used for a prolonged period, we recommend storing with a desiccant (silica gel). [. . . ] D Objektiv ansetzen/abnehmen E Manufactured by: SQT1215 F0316KD0 D Attaching/Detaching the Lens Panasonic Corporation Kadoma, Osaka, Japan Importer for Europe: Panasonic Marketing Europe GmbH Panasonic Testing Centre Winsbergring 11, 22525 Hamburg, Germany Panasonic Corporation Web Site: http://www. Com For information on how to attach and remove the lens, refer to the operating instructions for your digital camera. € Before attaching or detaching the lens, check that the digital camera is turned off. € Before attaching the lens to the digital camera, remove the lens rear cap A by rotating it in the direction of the arrow. (See illustration ) • After detaching the lens from the digital camera, be sure to attach the lens cap/lens rear cap. Troubleshooting A sound is heard when the camera is turned on or off. € This is the sound of lens or aperture movement and is not a malfunction. When this lens is attached to digital camera, stabilizer function cannot be turned off or stabilizer function does not work. € The Optical Image Stabilizer function of this lens only works correctly with supported cameras. > When older Panasonic digital cameras (DMC-GF1, DMC-GH1, DMC-G1) are used, [Stabilizer] in the [Rec] mode menu cannot be set to [OFF]. It is recommended to update the firmware of the digital camera at the following website. Jp/support/global/cs/dsc/download/ > When using this lens with another make of digital cameras, contact the respective company about details. ˆ Filter aufsetzen ∫ Attaching Filters  Panasonic Corporation 2016 • Vignetting may occur if using 2 or more filters at the same time. € It is possible to attach the lens cap with the filter already attached. € When using the lens hood and a filter at the same time, attach the filter first. € You cannot attach a conversion lens or adaptor to this lens. A filter may be used, but attaching any other element may cause damage to the lens. Vermeidung von Störungen ∫ Objektivpflege ∫ Attaching the Lens Hood (Supplied Accessory) Specifications Specifications are subject to change without notice. 82 feet) to ¶ (Tele) (from the focus distance reference line) Maximum image magnification 0. ] switch None (Setting of the [Stabilizer] is done in [Rec] mode menu by LUMIX digital cameras. 80 inch) (from the tip of the lens to the base side of the lens mount) Mass Approx. 46 lb) Dust-proof and splash-proof Available 1 2 Precautions (See illustration / ) Hold the lens hood with your fingers placed as shown in the picture (B). [. . . ] Panasonic Authorised Service Centres are located in major metropolitan areas and most regional centres of Australia, however, coverage will vary dependant on product. For advice on exact Authorised Service Centre locations for your product, please telephone our Customer Care Centre on 132600 or visit our website and use the Service Centre Locator. In addition to your rights under this warranty, Panasonic products come with consumer guarantees that cannot be excluded under the Australian Consumer Law. If there is a major failure with the product, you can reject the product and elect to have a refund or to have the product replaced or if you wish you may elect to keep the goods and be compensated for the drop in value of the goods. [. . . ]