User manual PANASONIC H-FS14140E

[. . . ] ‰ Four ThirdsTM and Four Thirds Logo marks are trademarks or registered trademarks of Olympus Imaging Corporation, in Japan, the United States, the European Union and other countries. ≥ G MICRO SYSTEM is an interchangeable lens type digital camera system of LUMIX based on a Micro Four Thirds System standard. ‰ Other names of systems and products mentioned in these instructions are usually the registered trademarks or trademarks of the manufacturers who developed the system or product concerned. Book 3 ページ ２０１３年４月１２日　金曜日　午後２時２分 ENGLISH -If you see this symbol- Information on Disposal for Users of Waste Electrical & Electronic Equipment (private households) This symbol on the products and/or accompanying documents means that used electrical and electronic products should not be mixed with general household waste. [. . . ] ) 3 Zoom ring Rotate the zoom ring when you wish to take large (tele) or wide (wide angle) pictures. € When taking pictures while following a moving subject. € When the shutter speed becomes slower to take pictures indoors or in dark places. Note ≥ When flash recording with a close subject, the light of the flash will be blocked by the lens and part of the picture may be dark. Check the distance from the subject when recording. ‰ If you zoom after focusing, focusing errors may occur. After zooming, please perform the focusing again. Attaching/Detaching the Lens ≥ Refer also to the camera’s operating instructions for attaching and detaching the lens. ‰ Remove the lens rear cap from the lens. ˆ Attaching the Lens Align the lens fitting marks A on the camera body and the lens and then rotate the lens in the direction of the arrow until it clicks. € Do not press the lens release button B when you attach a lens. € Do not try to attach the lens when holding it at an angle to the camera body as the lens mount may get scratched. • Check that the lens is attached correctly. € Be sure to remove the lens cap when recording. Book 7 ページ ２０１３年４月１２日　金曜日　午後２時２分 ∫ Detaching the Lens While pressing on the lens release button B, rotate the lens toward the arrow until it stops and then remove. € Attach the lens rear cap so that the lens contact point does not get scratched. € Attach the body cap to the camera so no dirt or dust will get inside the main unit. ˆ Attaching the Lens Hood (Supplied Accessory) Hold the lens hood with your fingers placed as shown in the picture. € Do not hold the lens hood in a way that twists or bends it. 1 Align the fitting mark C on the short side of the lens hood with the mark on the tip of the lens. 2 Turn the lens hood in the direction of the arrow until it stops, and align the stop mark D on the long side of the lens hood with the mark on the tip of the lens. Book 8 ページ ２０１３年４月１２日　金曜日　午後２時２分 ∫Temporarily Storing the Lens Hood 1 Turn the lens hood in the direction of the arrow to detach it. [. . . ] ‰ Use a dry, dust cloth to remove dirt and dust on the zoom ring and the focus ring. ≥ Do not use a household detergent or a chemically treated cloth. Troubleshooting A sound is heard when the camera is turned on or off. ‰ This is the sound of lens or aperture movement and is not a malfunction. [. . . ]