User manual PANASONIC HH-020AE

[. . . ] ‰¥ Four ThirdsTM and Four Thirds Logo marks are trademarks or registered trademarks of Olympus Imaging Corporation, in Japan, the United States, the European Union and other countries. ≥ G MICRO SYSTEM is an interchangeable lens type digital camera system of LUMIX based on a Micro Four Thirds System standard. ‰¥ Other names of systems and products mentioned in these instructions are usually the registered trademarks or trademarks of the manufacturers who developed the system or product concerned. Book 3 ページ ２０１３年５月３１日　金曜日　午後４時５４分 ENGLISH -If you see this symbol- Disposal of Old Equipment Only for European Union and countries with recycling systems This symbol on the products, packaging, and/or accompanying documents means that used electrical and electronic products must not be mixed with general household waste. [. . . ] As a result of this, there are operating sounds and vibrations when focusing, but this is not a malfunction. Operating sounds are recorded when auto-focusing during motion picture recording. If operating sounds become bothersome, we recommend setting to manual focus ([MF]) and fixing focus before recording to avoid recording the lens noise. Attaching/Detaching the Lens 1 1 Lens surface 2 Focus ring Rotate to focus when taking pictures with manual focus. 2 3 3 Contact point 4 Lens fitting mark ≥ Refer also to the camera’s operating instructions for attaching and detaching the lens. ‰¥ Check that the camera is turned off. ‰¥ Remove the lens rear cap from the lens. Book 7 ページ ２０１３年５月３１日　金曜日　午後４時５４分 ∫ Attaching the Lens Align the lens fitting marks A on the camera body and the lens and then rotate the lens in the direction of the arrow until it clicks. €¢ Do not press the lens release button B when you attach a lens. €¢ Do not try to attach the lens when holding it at an angle to the camera body as the lens mount may get scratched. • Check that the lens is attached correctly. €¢ Be sure to remove the lens cap when recording. ˆ« Detaching the Lens While pressing on the lens release button B, rotate the lens toward the arrow until it stops and then remove. €¢ Attach the lens rear cap so that the lens contact point does not get scratched. €¢ Attach the body cap to the camera so no dirt or dust will get inside the main unit. Book 8 ページ ２０１３年５月３１日　金曜日　午後４時５４分 ∫Attaching Filters ≥ Vignetting may occur if using 2 or more MC protectors (optional:DMW-LMC46), PL filters (optional:DMW-LPL46) or ND filters (optional:DMW-LND46), or if using thick protectors and/or filters. ‰¥ The filter may become impossible to remove if excessively tightened, so please refrain from tightening it too strongly. ‰¥ It is possible to attach the lens cap with the filter already attached. ‰¥ If you have problems with the attachment or removal of the PL filter (optional:DMW-LPL46), we recommend turning on the digital camera and trying again with the focus mode set to “manual” ([MF]). ‰¥ You cannot attach a conversion lens or adaptor to this lens. A filter may be used, but attaching any other element may cause damage to the lens. Cautions for Use Take care not to drop or knock the lens. [. . . ] Troubleshooting A sound is heard when the camera is turned on or off. A sound is heard from the lens when taking a picture of a bright subject such as when outdoors. ‰¥ This is the sound of lens or aperture movement and is not a malfunction. Book 10 ページ ２０１３年５月３１日　金曜日　午後４時５４分 Specifications Specifications are subject to change without notice. [. . . ]