User manual PANASONIC HH025E

[. . . ] Also take care not to put a lot of pressure on the lens. € Take care not to drop the bag that you inserted the lens in as it may strongly shock the lens. The camera may stop operating normally and pictures may no longer be recorded. When using pesticides and other volatile substances around the camera make sure that they do not get onto the lens. [. . . ] The lens can be used with a digital camera compatible with the lens mount standard for the “Micro Four ThirdsTM System”. € It cannot be mounted on the Four ThirdsTM mount specification camera. • The digital camera illustrations in these operating instructions show DMC-G7 as an example. € The appearance and specifications of products described in this manual may differ from the actual products you have purchased due to later enhancements. € Micro Four ThirdsTM and Micro Four Thirds Logo marks are trademarks or registered trademarks of Olympus Imaging Corporation, in Japan, the United States, the European Union and other countries. € Four ThirdsTM and Four Thirds Logo marks are trademarks or registered trademarks of Olympus Imaging Corporation, in Japan, the United States, the European Union and other countries. • G MICRO SYSTEM is an interchangeable lens type digital camera system of LUMIX based on a Micro Four Thirds System standard. € Other names of systems and products mentioned in these instructions are usually the registered trademarks or trademarks of the manufacturers who developed the system or product concerned. € Refer also to the camera’s operating instructions for attaching and detaching the lens. € Remove the lens rear cap from the lens. ˆ Attaching the Lens (See illustration ) Align the lens fitting marks A on the camera body and the lens and then rotate the lens in the direction of the arrow until it clicks. Com  Panasonic Corporation 2015 ∫ Detaching the Lens (See illustration • Do not press the lens release button B when you attach a lens. € Do not try to attach the lens when holding it at an angle to the camera body as the lens mount may get scratched. • Check that the lens is attached correctly. ˆ Gegenlichtblende aufsetzen (Mitgeliefertes 1 ) While pressing on the lens release button B, rotate the lens toward the arrow until it stops and then remove. € When rotating the lens, hold C, the portion near the base of the lens. € Attach the lens rear cap so that the lens contact point does not get scratched. € Attach the body cap to the camera so no dirt or dust will get inside the main unit. Troubleshooting A sound is heard when the camera is turned on or off. A sound is heard from the lens when taking a picture of a bright subject such as when outdoors. € This is the sound of lens or aperture movement and is not a malfunction. Vermeidung von Störungen ∫ Objektivpflege 1 SYF0073 2 VFC4605 ∫ Attaching the Lens Hood (Supplied 1 2 3 3 SYQ0570 SYQ0571 4 SDW0294K SDW0294S Accessory) (See illustration ) Rotate the decoration ring D in the direction of the arrow and then remove. [. . . ] Panasonic Authorised Service Centres are located in major metropolitan areas and most regional centres of Australia, however, coverage will vary dependant on product. For advice on exact Authorised Service Centre locations for your product, please telephone our Customer Care Centre on 132600 or visit our website and use the Service Centre Locator. In addition to your rights under this warranty, Panasonic products come with consumer guarantees that cannot be excluded under the Australian Consumer Law. If there is a major failure with the product, you can reject the product and elect to have a refund or to have the product replaced or if you wish you may elect to keep the goods and be compensated for the drop in value of the goods. [. . . ]