User manual PANASONIC KXHNC600E

[. . . ] Installation Guide Home Network System Outdoor Camera Model No. KX-HNC600E Thank you for purchasing a Panasonic product. This document explains how to install the outdoor camera properly. For details about how to use the system, refer to the User’s Guide (page 29). Please read this document before using the unit and save it for future reference. [. . . ] 3 m Visitors pass in front of the camera from side to side, cars in the street are less likely to cause false detections. Cars in the street are more likely to cause false detections. 14 Helpline Tel. 0330 3331112 Ireland 01 4475228 HNC600E_(en_en)_0421_ver. 050. pdf 14 2015/04/21 11:44:20 Installation Location I want to detect people entering the garage Refer to the table below for detecting people entering a garage without detecting cars in the street. Ideal example Poor example Visitors pass in front of the camera from side to side, cars in the street are less likely to cause false detections. R To prevent faces from being obscured by tall vehicles, adjust the installation position and angle of the camera. Cars in the street are more likely to cause false detections. Helpline Tel. 0330 3331112 Ireland 01 4475228 15 HNC600E_(en_en)_0421_ver. 050. pdf 15 2015/04/21 11:44:20 Installation Location Do not install in these locations Installing in the following areas may cause deformation, discolouration, malfunction, or operational failure R In direct sunlight or directly under an outdoor light (even if the surroundings are within operational temperature range, parts of the product may become hot) R Areas subject to frequent vibration, shock, or impact R Near fire, heating devices, magnetic fields (such as near magnets), or air conditioners (including outdoor equipment such as unit compressors) R Areas exposed to grease or steam R Near devices that emit strong radio waves, such as mobile phones R Areas subject to extreme temperature changes (which can lead to condensation) R Near coasts directly subjected to sea breezes, or near sulphuric hot springs (exposure to salt can shorten the life of the product) R Near TVs, radios, automated office equipment such as computers, air conditioners, water heater panels (with intercom), or home security equipment (these may cause noise) R Near satellite broadcasting receivers such as tuners, TVs with built-in satellite tuners, and recorders (broadcasted images may be distorted) R Areas where hydrogen sulphide, ammonia, dust, or toxic gases are present Installing in the following areas may cause false detections R Areas where people approach directly from the front of the camera, such as narrow walkways 1 Camera 2 Difficult to detect 2 1 R Areas where objects such as trees or hanging laundry move due to wind (temperature variation and motion may cause false detections) R On roads with high traffic (passing cars may cause sensor detections even if they are 5 m or more away) 16 Helpline Tel. 0330 3331112 Ireland 01 4475228 HNC600E_(en_en)_0421_ver. 050. pdf 16 2015/04/21 11:44:20 Installation Location R Areas affected by breezes from fans, air conditioning unit compressors, water heaters, or car exhaust (severe temperature variations may cause false detections) R Areas subject to severe weather, such as strong wind (camera shake can cause false detections) or rain (strong rain may be detected as an object moving in front of the camera) R Areas with reflective objects, such as glass, that can interfere with detection of temperature variation R Areas where brightness changes easily (such as areas where shadows form in the afternoon and lights turn on at night) R Areas where backlight occurs (faces appear dark and are difficult to identify), such as the following – Areas where most of the background is the sky – Areas where direct sunlight reflects off a white wall or background – Bright areas such as those exposed to direct sunlight Helpline Tel. 0330 3331112 Ireland 01 4475228 17 HNC600E_(en_en)_0421_ver. 050. pdf 17 2015/04/21 11:44:20 Setup Indicator Status Live images are being viewed or recorded Camera is out of range of the hub, or device malfunction Camera is not registered to a hub Part names and functions G H Red, blinking Red, blinking quickly Amber, blinking I *1 You can configure the camera so that its LED indicator does not light during normal operation. For more information, refer to the User’s Guide (page 29). A B CD E F J Setup overview 1 Initial setup Make sure you can access the system using your mobile device. For details, refer to the System Setup Guide included with your hub. Registration Required only if the camera was purchased separately (i. e. , not as part of a bundle). Confirm the installation area Read the information in this document to confirm that the desired installation area is suitable to proper operation. Installation Install the camera in the desired location and connect the camera to the power outlet. Adjust the infrared sensor range Confirm the sensor range area and adjust it if necessary using the included sensor range adjustment caps. Microphone Sensor range cap (Standard) Infrared sensor LED indicator Lens unit Speaker M N Used when registering the camera to the hub. Safety wire Camera mounting stand DC cable 2 3 4 LED indicator You can use the LED indicator to confirm the camera’s status. Indicator Off Status No power, or LED indicator is turned off*1 Normal operation*1 Registration mode Motion detected 5 Green, lit Green, blinking Red 18 Helpline Tel. 0330 3331112 Ireland 01 4475228 HNC600E_(en_en)_0421_ver. 050. pdf 18 2015/04/21 11:44:20 Setup Registering the camera This procedure is not required for devices that were included as part of a bundle. Before you can use the camera, it must be registered to the hub. If the camera is not registered to a hub, the camera’s LED indicator blinks in amber. You can register each device by using the registration buttons or the [Home Network] app. Note: R Before registering the camera, make sure the AC adaptors of the hub and camera are connected and each device is powered. Using the app When you register the camera by using the [Home Network] app, you can assign a name to your devices and group them by location. For more information, refer to the User’s Guide (page 29). Confirming the registration area Before deciding where to install the camera, carefully read the chapter “Installation Location”, beginning on page 11, to confirm the installation location and direction. Using registration buttons 1 2 Hub: Press and hold M CAMERAN until the LED indicator blinks in green. Camera: Using an object with a thin tip, press and hold M N until the LED indicator blinks in green (page 18). [. . . ] 50° R IP rating IP55*2 R Adjustable mounting angles Horizontal: ±90° Vertical: facing forward - facing down approx. 60° (adjustable when mounting) R Dimensions (height ´ width ´ depth) Approx. 75 mm ´ 75 mm ´ 173 mm R Mass (weight) Approx. 305 g *1 The IR-LED will be lighted at the low illuminance conditions. [. . . ]