User manual PANASONIC KXHNK101E

[. . . ] Operating Instructions Home Network System Access Keypad Model No. KX-HNK101E Thank you for purchasing a Panasonic product. This document explains how to operate the access keypad properly. For details about how to use the system, refer to the User’s Guide (page 16). Please read this document before using the unit and save it for future reference. For dedicated help, support, or advice, available to help you Monday Friday, 09:00 - 23:00. [. . . ] When wiping the touchpanel, use your fingers to gently hold it in place, taking care not to scratch it with your fingernails. This symbol on the products, packaging, and/or accompanying documents means that used electrical and electronic products must not be mixed with general household waste. For proper treatment, recovery and recycling of old products, please take them to applicable collection points in accordance with your national legislation. By disposing of them correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment. For more information about collection and recycling, please contact your local municipality. Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation. Helpline Tel. 0330 3331112 Ireland 01 4475228 7 HNK101_(en_en)_0901_ver. 003. pdf 7 2015/09/01 13:25:39 Setup Part names and functions D A B C Touchpanel buttons These buttons allow you to confirm and change the system’s arm mode. During normal operation, the button that corresponds to the current arm mode is lit by default, and all other buttons are dimmed. When you tap the touchpanel, the arm mode buttons light for 10 seconds. During this time, you can tap an arm mode button to switch to the corresponding arm mode. Button Status No power, or buttons are turned off*1. Normal operation, [Arm: At Home] mode is selected. Normal operation, [Arm: Away] mode is selected. Normal operation, [Disarm] mode is selected. Registration mode (you pressed and held N) M None displayed , lit E F G , lit , lit Current arm mode button blinking slowly All buttons blinking slowly *1 M N Used when registering the keypad to the hub. Volume Used to adjust the volume of the sounds emitted by the keypad. Speaker Touchpanel When no buttons are displayed here, touch this area to display the buttons. Touchpanel buttons LED indicator DC jack You can configure the keypad so that its arm mode buttons do not light during normal operation. For more information, refer to the User’s Guide (page 16). 8 Helpline Tel. 0330 3331112 Ireland 01 4475228 HNK101_(en_en)_0901_ver. 003. pdf 8 2015/09/01 13:25:39 Setup LED indicator You can use the LED indicator to confirm the keypad’s status. Indicator Off Red, blinking slowly Red, blinking Red, blinking quickly Green, blinking slowly Status Normal operation, or no power Keypad is not registered to a hub. Registration mode (You pressed and held M N) Registering the keypad This procedure is not required for devices that were included as part of a bundle. Wireless communication may be unreliable when the following obstacles are located between the hub and other devices. [. . . ] R You can also access the User’s Guide at the web page listed below. 0 °C – 40 °C R Dimensions (height ´ width ´ depth) Approx. 120 mm ´ 120 mm ´ 21 mm R Mass (weight) Approx. 163 g (without the mounting bracket attached) www. panasonic. net/pcc/support/tel/ homenetwork/manual/ Specifications R Standards DECT (Digital Enhanced Cordless Telecommunications) R Frequency range DECT: 1. 88 GHz – 1. 90 GHz R RF transmission power Approx. : 10 mW (average power per channel) R Power source 220 – 240 V AC, 50/60 Hz R Power consumption Standby: Approx. [. . . ]