User manual PANASONIC KXHNS105

[. . . ] Com/prodreg In order to use this device: R Download the latest version of the [Home Network] app. R Update your hub to the latest firmware version (version 5. For more information, refer to the User’s Guide (page 12). 12 Features available when using the [Home Network] app . [. . . ] R The product should be kept away from heat sources such as heaters, kitchen stoves, etc. It should not be placed in rooms where the temperature is less than 0 °C (32 °F) or greater than 40 °C (104 °F). R Operating the product near electrical appliances may cause interference. Move away from the electrical appliances. Other information Routine care R Wipe the outer surface of the product with a soft moist cloth. R Do not use benzine, thinner, or any abrasive powder. Pdf 6 2015/02/09 21:38:39 Setup Part names and functions LED indicator You can use the LED indicator to confirm the siren’s status. Indicator Green, lit Red, blinking slowly Red, blinking Red, blinking quickly Green, blinking Status Normal operation Siren is not registered to a hub Siren is out of range of the hub Alarm system was triggered Registration mode (You pressed and held M N) No power A B C D E Off F Setup overview 1 Initial setup Make sure you can access the system using your mobile device. For details, refer to the System Setup Guide included with your hub. Registration Required only if the siren was purchased separately (i. Confirm the installation area Read the information in this document to confirm that the desired installation area is suitable to proper operation. Note: R The strobe light flashes when the siren sounds. Mount the siren in a location where its strobe light will be visible. R Mount the siren on the stable location where the siren can be adequately supported when mounting. Vibrations may cause it to fall if it is not secured. R Do not mount siren on a soft material. It may fall down, break or cause injury. R Do not mount the siren on the following places: gypsum board, ALC (autoclaved lightweight cellular concrete), concrete block, plywood less than 25. 1 Remove the rear cover by pressing the upper sides of the cover (A) and sliding it down (B). A B 2 Attach the rear cover to the wall by using screws (1). R Place the rear cover with “UP” mark facing upwards. Pdf 10 2015/02/09 21:38:39 Setup 3 Use the DC extension cord (A) to connect the AC adaptor (B) to the siren. [. . . ] You must mail-in your product prepaid during the Limited Warranty period. This Limited Warranty excludes both parts and labor for batteries, antennas, and cosmetic parts (cabinet). This Limited Warranty only applies to products purchased and serviced in the United States or Puerto Rico. This Limited Warranty is extended only to the original purchaser and only covers products purchased as new. [. . . ]