User manual PANASONIC KX-MB2060

[. . . ] Operating Instructions Model No. KX-MB2060 KX-MB2061 Multi-Function Printer The pictured model is KX-MB2061. Do NOT connect the unit to a computer with the USB cable until prompted to do so during the setup of Multi-Function Station (CD-ROM). 1 2 For hearing or speech impaired TTY users, TTY: 1-877-833-8855 Important: L To use cordless handset features with KX-MB2060, please purchase an additional digital cordless handset (page 8). R This unit is compatible with Caller ID. Subscription to the appropriate service through your service provider/telephone company is required. Thank you for purchasing a Panasonic product. R Base unit: The voice guidance, display and reports will be in the selected language. If you want to change the setting, see feature #110 on page 78 and feature #112 on page 88. [. . . ] R The receiving mode will be set to TAM/FAX or FAX ONLY mode, depending on the setting of feature #400 (page 81). Hang up the handset. 10. 10. 1 Recording your greeting message 1 MMENUN (soft key A) A M#NM3NM0NM2N 2 "Yes" A MSELECTN (soft key A) 3 After a beep sounds, hold the cordless handset about 20 cm (8 inches) away and speak clearly into the microphone (60 seconds max. ). R The greeting message will be played. 4 Press MSTOPN (soft key A) to stop recording. 5 MOFFN To check the greeting message 1. MOFFN To reset to a pre-recorded greeting message If you want to use a pre-recorded greeting message once you record your own greeting message, you need to erase your own greeting message. Answering Machine Using a pre-recorded greeting message The unit provides 2 pre-recorded greeting messages: ­ If you erase or do not record your own greeting message, the unit plays a pre-recorded greeting asking callers to leave a message. ­ If the message recording time (feature #305 on page 76, 88) is set to "GREET ONLY"/ "Greeting only", callers' messages are not recorded and the unit plays a different pre-recorded greeting message asking callers to call again. "Edit & Call" A MSELECTN (soft key A) 3. Press MEDITN (soft key A) repeatedly until the telephone number is shown in the desired format (page 55). A M N 10. 10. 4 Erasing voice messages To erase a specific message Press MGNM4N while listening to the message you want to erase. "Yes" A MSELECTN (soft key A) A MOFFN 10. 10. 2 Recording a telephone conversation 1 Press MHNMBNM1N during a conversation. 2 Press MHNMBNM2N to stop recording. 10. 10. 3 Listening to voice messages When new messages have been recorded: ­ "New message" is displayed. ­ The message indicator on the cordless handset flashes slowly if the message alert feature is turned ON (feature #340 on page 76). 10. 10. 5 Direct command operation You can operate the answering machine by pressing dial keys, rather than navigating through the menus. To use the following commands, press MMENUN (soft key A). A "Answering device" A MSELECTN (soft key A) Key MCN or MDN M1N or MFN M2N or MEN M3N M4N M5N M6N M7NM6N Direct commands Adjust the receiver or speaker volume (during playback) Repeat message (during playback)*1 Skip message (during playback) Enter the "Settings" menu Play new messages Play all messages Play greeting message Record greeting message Turn auto answer setting ON Pause message*2 1 To listen to new messages: MPLAYN (soft key A) or MMENUN (soft key A) A M#NM3NM2NM3N R If there are no new messages in the answering machine, MPLAYN (soft key A) is not displayed. To listen to all messages: MMENUN (soft key A) A M#NM3NM2NM4N 2 When finished, press MOFFN. Note: R To switch to the receiver, press M To repeat a message Press M1N while listening to the message. R If you press M1N within first 5 seconds of a message, the previous message is played. To skip a message Press M2N to play the next message. To stop playback Press MSTOPN (soft key A). If you subscribe to Caller ID service If caller information is received for the call, you can call the caller back while listening to a message. Press MPAUSEN (soft key A) during playback. "Call back" A MSELECTN (soft key A) Note: To edit the number before calling back; 1. [. . . ] IN NO EVENT SHALL THE OpenSSL PROJECT OR * ITS CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, * SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT * NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; * LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, * STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED * OF THE POSSIBILITY OF SUCH DAMAGE. * ==================================================================== * * This product includes cryptographic software written by Eric Young * (eay@cryptsoft. com). This product includes software written by Tim * Hudson (tjh@cryptsoft. com). * */ Original SSLeay License ----------------------/* Copyright (C) 1995-1998 Eric Young (eay@cryptsoft. com) * All rights reserved. [. . . ]