User manual PANASONIC KX-TCD650

[. . . ] Model No: KX-TCD650E Digital Cordless Phone Operating Instructions & Quick Guide Centre Page Pullout Safety Information . For Optional Multi Unit Users Before Requesting Help . . 9 . 10 . 13 . 16 . 17 . 20 . 22 Caller ID compatible Please read before use and save Charge the batteries for approx. 15 hours before initial use General Safety Only use the power supply included with the product. [. . . ] ZS / U to select ni-mh (Ni-MH) or ni-cd (Ni-Cd). ZV. other opt (Other Options): ZV. ZS or U. registration (Registration):* ZV. ZS or U. hspin change (Change Handset PIN): You can change the 4 digit password for the handset. (If the PIN is entered incorrectly, an error tone sounds and display returns to new pin ____. Once you have programmed the password, you cannot confirm it. We recommend you write down the password. If you forget it, please consult our Panasonic Customer Care Helpline. 01289 8333 register hs (Registering a Handset to a Base Unit)* cancel base (Cancelling a Base Unit)* select bs (Select Base Unit)* *For information on registering handset(s), cancelling and selecting base unit(s), please refer to `For Optional Multi-Unit Users'. Handset Settings reset hs (Reset the Handset Settings): You can reset all of the handset settings to their initial factory settings (see `Handset Initial Settings'). cleared is displayed and display returns to settings menu. auto talk (Set Auto Talk ON/OFF): If you set Auto Talk to ON, you can answer the phone by lifting the handset off the base unit. 01289 8333 Base Unit Settings You can change the base unit settings using a handset near the base unit. Before proceeding with any of the base settings listed in this chapter, the following procedure must initially be carried out: 1 2 3 From the standby mode, ZV. ZS or U to select setting bs (Setting Base). From this display, follow the instructions after each heading. Please note: Where `Enter PIN' is stated in this chapter, it refers to the 4 digit Base Unit PIN. To exit the menu at any time, Z±. Ringer Mode To select all handsets to ring ZA. ZV. Select Base Unit Ringer Volume ZB twice. ZV. To select specific handset(s) to ring ZA. ZV. Selecting Time Break Recall (TBR) / Earth Recall Mode (option) The factory setting is time break recall (TBR). If your PBX requires earth recall mode, this can be added at an extra cost. Please contact our Customer Care Helpline for details. ZB then B for earth mode OR ZB then A for time break recall mode (TBR). [. . . ] 01289 8333 Technical Information Specifications: Standard: DECT=(Digital Enhanced Cordless Telecommunications). Up to 300m outdoors (line of sight), up to 50 m indoors. 5o - 40oC, 20 - 80% relative air humidity (dry) About 103mm x 122mm x 60mm x 180g About 134mm x 46mm x 30mm x 85g (without batteries) About 2. 3m About 1. 9m Power source: Power consumption, base unit: Operating conditions: Dimensions, Base Unit: Dimensions, Handset: Telephone line cord length: AC adaptor cord length: · Specifications are subject to change. · The illustrations used in this manual may differ slightly from the original device. Connections: · The telephone will not work during a power failure. We therefore recommend you use a standard telephone and T Adaptor to connect this Digital Cordless Phone to the line. [. . . ]