User manual PANASONIC KXTG1100AR

[. . . ] To use this unit in your country, first change the unit's region setting to match your country (page 31). Change the unit's display language as needed (page 15). (For Czech and Slovakia) This cordless telephone is possible to use according to General licence No. : VO-R/8/08. 2005-23 (for Czech), VPR-7/2001 (for Slovakia). TG7511_7521FX(e). book Page 2 Tuesday, March 9, 2010 3:22 PM Table of Contents Introduction Model composition . 40 Answering System Answering system . [. . . ] Go to step 4. 3 4 5 Enter the desired date and month. i M {V}/{^}: Select the desired alarm tone. i M L We recommend selecting a different ringer tone from the one used for outside calls. M i {ic} L When the alarm is set, E is displayed. 1 2 1 i {#}{2}{3}{8} {V}/{^}: Select the desired setting. iM L If you select "Off", press {ic} to exit. Enter the desired hour and minute you wish to start this feature. i M L You can select 24-hour or 12hour clock format ("AM" or "PM") by pressing /. Enter the desired hour and minute you wish to end this feature. i M {ic} L When the night mode is set, 3 is displayed. 3 6 Note: L To stop the alarm, press any dial key or place the handset on the base unit or charger. L When the handset is in use, the alarm will not sound until the handset is in standby mode. 4 5 30 TG7511_7521FX(e). book Page 31 Tuesday, March 9, 2010 3:22 PM Programming Note: L To correct a digit, press {<} or {>} to move the cursor to the digit, then make the correction. Changing the start and end time Changing the handset name Each handset can be given a customised name ("Bob", "Kitchen", etc. ). Additional base units Handsets can be registered to up to 4 base units, allowing you to add additional base units and extend the area in which your handset(s) can be used. If a handset moves out of range of its base unit when "Auto" is selected on base unit (page 34), it looks for another base unit to make or receive calls. A base unit and the handsets it communicates with is called a "radio cell". Note: L Calls are disconnected when the handset moves from one radio cell to another. 1 2 3 1 i {#}{2}{1}{7} {V}/{^}: Select the desired entry. To edit a number: ~ i Edit the phone number. i M i {ic} To erase a number: W i {V}/{^}: "Yes" i M i {ic} Note: L When editing, press the desired dial key to add, ^ to erase. Changing the base unit PIN (Personal Identification Number) Important: L If you change the PIN, please make note of your new PIN. The unit will not reveal the PIN to you. If you forget your PIN, contact an authorised service centre. 1 2 3 1 i {#}{1}{3}{2} Enter the current 4-digit base unit PIN (default: "0000"). i M i {ic} Registering a handset to a base unit The supplied handset and base unit are pre-registered. If for some reason the handset is not registered to the base unit (for example, _ is displayed even when the handset is near the base unit), reregister the handset. 1 Registering a unit Operating additional units Additional handsets Up to 6 handsets can be registered to a single base unit. Handset: 1 i {#}{1}{3}{0} {V}/{^}: Select a base unit number. iM L This number is used by the handset as a reference only. [. . . ] L The unit could not connect to the SMS message centre. Confirm that the correct SMS message centre numbers are stored. Confirm that SMS is turned on (page 38). L An error occurred while sending the message. [. . . ]