User manual PANASONIC KX-TG5521E

[. . . ] TG5521E(e). book Page 1 Tuesday, March 16, 2010 7:47 AM Operating Instructions Digital Cordless Answering System Model No. KX-TG5521E KX-TG5522E KX-TG5523E Model shown is KX-TG5521. Before initial use, see "Getting Started" on page 10. Thank you for purchasing a Panasonic product. Please read these operating instructions before using the unit and save them for future reference. You must subscribe to the appropriate service offered by your service provider/telephone company. Please access our online customer survey: http://panasonic. net/pcc/tel/q TG5521E(e). book Page 2 Tuesday, March 16, 2010 7:47 AM Table of Contents Introduction Model composition . [. . . ] You can also select whether or not the handset name is displayed in standby mode. If you select "On" without entering any handset name, "Handset 1" to "Handset 6" is displayed. 1 2 8 i {#}{7}{2}{0} {V}/{^}: Select the desired alarm option. "Once" An alarm sounds once at the set time. "Daily" An alarm sounds daily at the set time. Go to step 4. 1 2 3 4 5 8 i {#}{1}{0}{4} Enter the desired name (max. i M 2 times {ic} 3 4 5 Incoming call barring (Caller ID subscribers only) This feature allows the unit to reject calls from specified phone numbers that you do not want to answer such as junk calls. When a call is received, the unit does not ring while the caller is being identified. If the phone number matches an entry in the call barred list, the unit sends out a busy tone to the caller, and then disconnects the call. Important: L When the unit receives a call from a number that is stored in the call barred list, the call is logged in the caller list (page 29) with 7 after the call is disconnected. Storing unwanted callers You can store up to 30 phone numbers in the call barred list by using the caller list or by entering the numbers directly. Enter the desired date and month. i M {V}/{^}: Select the desired alarm tone. i M L We recommend selecting a different ringer tone from the one used for outside calls. M i {ic} L When the alarm is set, E is displayed. 6 Note: L To stop the alarm, press any dial key or place the handset on the base unit or charger. L When the handset is in use, the alarm will not sound until the handset is in standby mode. 26 Helpline Tel. 01289 8333 TG5521E(e). book Page 27 Tuesday, March 16, 2010 7:47 AM Programming Important: L You must store the phone number with an area code in the call barred list. From the caller list: reveal the PIN to you. If you forget your PIN, see page 43. 1 2 3 8 i {#}{1}{3}{2} Enter the current 4-digit base unit PIN (default: "0000"). i M i {ic} 1 2 3 4 1 2 3 {<} (y) {V}/{^}: Select the entry to be barred. i I {V}/{^}: "Caller Barred" i M {V}/{^}: "Yes" i M i {ic} 8 i {#}{2}{1}{7} i m Enter the phone number (24 digits max. ). {ic} Registering a unit Operating additional units Additional handsets Up to 6 handsets can be registered to the base unit. Important: L The additional handset model recommended for use with this unit is noted on page 4. If another handset model is used, certain operations (handset settings, base unit settings, etc. ) may not be available. By entering phone numbers: Viewing/editing/erasing bar call numbers 1 2 3 8 i {#}{2}{1}{7} {V}/{^}: Select the desired entry. [. . . ] Remove the batteries from the handset and leave to dry for at least 3 days. After the handset/base unit are completely dry, reconnect the AC adaptor and telephone line cord. Insert the batteries and charge fully before use. If the unit does not work properly, contact an authorised service centre. Caution: L To avoid permanent damage, do not use a microwave oven to speed up the drying process. Helpline Tel. [. . . ]