User manual PANASONIC KXTG6512FX

[. . . ] TG6511-6521FX(e). book Page 1 Wednesday, February 24, 2010 1:41 PM Operating Instructions Digital Cordless Phone Model No. KX-TG6511FX KX-TG6512FX KX-TG6521FX Digital Cordless Answering System Model No. Model shown is KX-TG6511. Before initial use, see "Getting Started" on page 11. Thank you for purchasing a Panasonic product. Please read these operating instructions before using the unit and save them for future reference. This unit is compatible with Caller ID and SMS. You must subscribe to the appropriate service offered by your service provider/telephone company. [. . . ] {ic} L After changing the unit's region setting/resetting the base unit, _ is displayed on the handset momentarily. This is normal and the handset can be used once w is displayed. By entering phone numbers: 30 TG6511-6521FX(e). book Page 31 Wednesday, February 24, 2010 1:41 PM Programming Viewing/editing/erasing bar call numbers Important: L The additional handset model recommended for use with this unit is noted on page 5. If another handset model is used, certain operations (handset settings, base unit settings, etc. ) may not be available. 1 2 3 8 i {#}{2}{1}{7} {V}/{^}: Select the desired entry. To edit a number: ~ i Edit the phone number. i M i {ic} To erase a number: W i {V}/{^}: "Yes" i M i {ic} Registering a handset to the base unit The supplied handset and base unit are pre-registered. If for some reason the handset is not registered to the base unit (for example, _ is displayed even when the handset is near the base unit), reregister the handset. Note: L When editing, press the desired dial key to add, ^ to erase. Changing the base unit PIN (Personal Identification Number) Important: L If you change the PIN, please make note of your new PIN. The unit will not reveal the PIN to you. If you forget your PIN, contact an authorised service centre. 1 2 Handset: 8 i {#}{1}{3}{0} Base unit: Proceed with the operation for your model. KX-TG6511/KX-TG6512 Press and hold {x} for about 5 seconds. (No registration tone) KX-TG6521 Press and hold {x} for about 5 seconds, until the registration tone sounds. L If all registered handsets start ringing, press the same button to stop. L The next step must be completed within 90 seconds. 1 2 3 8 i {#}{1}{3}{2} Enter the current 4-digit base unit PIN (default: "0000"). i M i {ic} Registering a unit Operating additional units Additional handsets Up to 6 handsets can be registered to the base unit. 3 Handset: Wait until "Base PIN" is displayed. i Enter the base unit PIN (default: "0000"). i M L If you forget your PIN, contact an authorised service centre. L When the handset has been registered successfully, w is displayed. 31 TG6511-6521FX(e). book Page 32 Wednesday, February 24, 2010 1:41 PM Programming Note: L While registering, "Base in registering" is displayed on all registered handsets. L When you purchase an additional handset, refer to the additional handset's installation manual for registration. Deregistering a handset A handset can cancel its own registration (or the registration of another handset) that is stored to the base unit. This allows the handset to end its wireless connection with the system. 2 {V}/{^}: Select the desired setting. i M i {ic} Note: L After turning the repeater mode on or off, _ is displayed on the handset momentarily. This is normal and the handset can be used once w is displayed. 1 2 3 8 i {#}{1}{3}{1} L All handsets registered to the base unit are displayed. {V}/{^}: Select the handset you want to cancel. [. . . ] Contact your service provider/ telephone company. "FD" is displayed. "FE" is displayed. "E0" is displayed. 55 TG6511-6521FX(e). book Page 56 Wednesday, February 24, 2010 1:41 PM Useful Information Answering system (KX-TG6521) Problem The unit does not record new messages. Cause/solution L The answering system is turned off. L The recording time is set to "Greeting Only". [. . . ]