User manual PANASONIC KXTG6521E

[. . . ] TG6511-6521E(e). book Page 1 Monday, January 11, 2010 8:48 AM Operating Instructions Digital Cordless Phone Model No. KX-TG6511E KX-TG6512E KX-TG6513E KX-TG6521E KX-TG6522E KX-TG6523E KX-TG6524E Digital Cordless Answering System Model No. Model shown is KX-TG6511. Before initial use, see "Getting Started" on page 11. Thank you for purchasing a Panasonic product. Please read these operating instructions before using the unit and save them for future reference. You must subscribe to the appropriate service offered by your service provider/telephone company. Please access our online customer survey: http://panasonic. net/pcc/tel/q TG6511-6521E(e). book Page 2 Monday, January 11, 2010 8:48 AM Table of Contents Introduction Model composition . [. . . ] "Once" An alarm sounds once at the set time. "Daily" An alarm sounds daily at the set time. Go to step 4. 1 2 3 4 5 8 i {#}{1}{0}{4} Enter the desired name (max. i M 2 times {ic} 3 4 5 Incoming call barring (Caller ID subscribers only) Available for: KX-TG6521/KX-TG6522/ KX-TG6523/KX-TG6524 This feature allows the unit to reject calls from specified phone numbers that you do not want to answer such as junk calls. When a call is received, the unit does not ring while the caller is being identified. If the phone number matches an entry in the call barred list, the unit sends out a busy tone to the caller, and then disconnects the call. Important: L When the unit receives a call from a number that is stored in the call barred list, the call is logged in the caller list (page 30) with 7 after the call is disconnected. Enter the desired date and month. i M {V}/{^}: Select the desired alarm tone. i M L We recommend selecting a different ringer tone from the one used for outside calls. M i {ic} L When the alarm is set, E is displayed. 6 Note: L To stop the alarm, press any dial key or place the handset on the base unit or charger. L When the handset is in use, the alarm will not sound until the handset is in standby mode. Helpline Tel. 01289 8333 27 TG6511-6521E(e). book Page 28 Monday, January 11, 2010 8:48 AM Programming Storing unwanted callers You can store up to 30 phone numbers in the call barred list by using the caller list or by entering the numbers directly. Important: L You must store the phone number with an area code in the call barred list. From the caller list: Changing the base unit PIN (Personal Identification Number) Important: L If you change the PIN, please make note of your new PIN. The unit will not reveal the PIN to you. If you forget your PIN, see page 44. 1 2 3 4 1 2 3 {<} (y) {V}/{^}: Select the entry to be barred. i I {V}/{^}: "Caller Barred" i M {V}/{^}: "Yes" i M i {ic} 8 i {#}{2}{1}{7} i m Enter the phone number (24 digits max. ). {ic} 1 2 3 8 i {#}{1}{3}{2} Enter the current 4-digit base unit PIN (default: "0000"). i M i {ic} By entering phone numbers: Registering a unit Operating additional units Additional handsets Up to 6 handsets can be registered to the base unit. Important: L The additional handset model recommended for use with this unit is noted on page 4. If another handset model is used, certain operations (handset settings, base unit settings, etc. ) may not be available. Viewing/editing/erasing bar call numbers 1 2 3 8 i {#}{2}{1}{7} {V}/{^}: Select the desired entry. To edit a number: ~ i Edit the phone number. [. . . ] After the handset/base unit are completely dry, reconnect the AC adaptor and telephone line cord. Insert the batteries and charge fully before use. If the unit does not work properly, contact an authorised service centre. Caution: L To avoid permanent damage, do not use a microwave oven to speed up the drying process. Wall mounting Note: L Make sure that the wall is strong enough to support the weight of the unit. Base unit Charger 25 mm 57 mm Screws (Not supplied) Screws (Not supplied) Hooks Hook 48 Helpline Tel. [. . . ]