User manual PANASONIC KXTG6824G

[. . . ] Place the product securely on a stable surface. Serious damage and/or injury may result if the product falls. Do not cover slots and openings on the product. They are provided for ventilation and protection against overheating. [. . . ] · Once new calls have been checked, "NEW" is not displayed. Character table Key [1] [2] [3] [4] [5] [6] [7] [8] [9] [] [] Character Space * !A B C ( D E F ) G H I " J K L ' M N O ; P Q R S T U V ?W X Y Z To move the cursor to the left To move the cursor to the right Special features 16 Special features Automatic security code setting When you place the handset on the base unit for the first time after connecting the AC adaptor, the unit automatically selects one of more than 65, 000 security codes. 19 Troubleshooting General use Problem The unit does not work. 20 FCC and other information This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the bottom of this equipment is a label that contains, among other information, a product identifier in the format US:5GG------. If requested, this number must be provided to the telephone company, · · Registration No. ------------------- (found on the bottom of the unit) Ringer Equivalence No. (REN) ------------------- 0. 0B NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ­ Increase the separation between the equipment and receiver. Handset 2: ] on the receiving handset to answer the Press [TRANSFER] or [ call. · To cancel the call transfer, you may press [OFF], [TRANSFER], or [ ] on the originating handset. A plug and jack used to connect this equipment to the premises wiring and telephone network must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A compliant telephone cord and modular plug is provided with the product. It is designed to be connected to a compatible modular jack that is also compliant. The REN is used to determine the number of devices that may be connected to a telephone line. Excessive RENs on a telephone line may result in the devices not ringing in response to an incoming call. In most but not all areas, the sum of RENs should not exceed five (5. 0). To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact the local telephone company. For products approved after July 23, 2001, the REN for the product is part of the product identifier that has the format US:AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal point (e. g. , 03 is a REN of 0. 3). If this equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. [. . . ] - If a call is being transferred to you, the caller information is not displayed. - Generally, caller information is displayed from the 2nd ring. - The phone number you dialed might have an incorrectly edited pattern (for example, the long distance "1" or the area code is missing). Edit the phone number with another pattern. [. . . ]