User manual PANASONIC KXTG7521E

[. . . ] TG7521E(e). book Page 1 Friday, January 22, 2010 8:46 AM Operating Instructions Digital Cordless Answering System Model No. KX-TG7521E KX-TG7522E KX-TG7523E KX-TG7524E Model shown is KX-TG7521. Before initial use, see "Getting Started" on page 9. Thank you for purchasing a Panasonic product. Please read these operating instructions before using the unit and save them for future reference. This unit is compatible with Caller ID and SMS. You must subscribe to the appropriate service offered by your service provider/telephone company. [. . . ] To edit a number: ~ i Edit the phone number. i M i {ic} To erase a number: W i {V}/{^}: "Yes" i M i {ic} Note: L When editing, press the desired dial key to add, ^ to erase. Changing the base unit PIN (Personal Identification Number) Important: L If you change the PIN, please make note of your new PIN. The unit will not reveal the PIN to you. If you forget your PIN, see page 53. Registering a handset to a base unit The supplied handset and base unit are pre-registered. If for some reason the handset is not registered to the base unit (for example, _ is displayed even when 1 2 30 1 i {#}{1}{3}{2} Enter the current 4-digit base unit PIN (default: "0000"). Helpline Tel. 01289 8333 TG7521E(e). book Page 31 Friday, January 22, 2010 8:46 AM Programming the handset is near the base unit), reregister the handset. 2 1 2 Handset: 1 i {#}{1}{3}{0} {V}/{^}: Select a base unit number. iM L This number is used by the handset as a reference only. Base unit: Press and hold {x} for about 5 seconds, until the registration tone sounds. L If all registered handsets start ringing, press the same button to stop. L The next step must be completed within 90 seconds. Handset: Wait until "Base PIN" is displayed. i Enter the base unit PIN (default: "0000"). i M L If you forget your PIN, see page 53. L When the handset has been registered successfully, w is displayed. {V}/{^}: Select the desired base unit number, or "Auto". i M L The handset starts searching for the base unit. 3 Deregistering a handset A handset can cancel its own registration (or the registration of another handset) that is stored to the base unit. This allows the handset to end its wireless connection with the system. 1 2 3 1 i {#}{1}{3}{1} L All handsets registered to the base unit are displayed. {V}/{^}: Select the handset you want to cancel. i M {V}/{^}: "Yes" i M L A confirmation tone sounds. L The handset does not beep when cancelling its own registration. {ic} 4 4 Note: L While registering, "Base in registering" is displayed on all registered handsets. L When you purchase an additional handset, refer to the additional handset's installation manual for registration. Selecting a base unit When "Auto" is selected, the handset automatically uses any available base unit it is registered to. [. . . ] After the handset/base unit are completely dry, reconnect the AC adaptor and telephone line cord. Insert the batteries and charge fully before use. If the unit does not work properly, contact an authorised service centre. Caution: L To avoid permanent damage, do not use a microwave oven to speed up the drying process. Helpline Tel. 01289 8333 57 TG7521E(e). book Page 58 Friday, January 22, 2010 8:46 AM Useful Information Conditions of guarantee This guarantee is in addition to and does not in any way affect any statutory or other rights of consumer purchasers. [. . . ]