User manual PANASONIC KX-TG8321FX

[. . . ] By pressing a soft key, or by pressing the centre of the joystick, you can select the feature shown directly above it on the display. Menu icons When in standby mode, pressing down on the centre of the joystick reveals the handset's main menu. From here you can access various features and settings. Icon j X K Feature Caller List SMS (Short Message Service) Time Settings*1 Icon I N !# Feature Answer System*2 Handset Setup Base Unit Setup Incoming No. [. . . ] Making calls 1 n (left soft key) 2 {V}/{^}: Select the desired entry. L You can scroll through the phonebook entry by pushing and holding the joystick down or up. 3 {C} Answering system (Base unit): KX-TG8321 Answering on/off Listening to messages Press {s} to turn on/off the answering system. {6} ­5­ TG8301_8321FX(e)_QG. fm Page 6 Tuesday, April 1, 2008 11:06 AM Frequently asked questions Question Why is w flashing?Cause/solution L The handset is too far from the base unit. L The base unit's AC adaptor is not connected. L You are using the handset or base unit in an area with high electrical interference. Place the base unit and use the handset away from sources of interference. L The handset is not registered to the base unit. L The dialling mode may be set incorrectly. Activate the handset display again by: ­ pushing the joystick left {<} or right {>} when on a call. L "LCD Dimming" is set to "Off" while on charge. L Make sure the batteries are installed correctly. L Clean the charge contacts and charge again. L When you are using fully-charged Ni-MH batteries (supplied batteries); In continuous use: 15 hours max. Not in use (standby): 250 hours (10 days) max. L It is normal for batteries not to reach full capacity at the initial charge. Maximum battery performance is reached after a few complete cycles of charge/discharge (use). L Actual battery performance depends on a combination of how often the handset is in use and how often it is not in use (standby). L Even after the handset is fully charged, the handset can be left on the base unit or charger without any ill effect on the batteries. L If the batteries are fully charged until & is displayed, but ) is displayed after a few calls, replace the batteries with new ones. Why can I not make calls?Why is the handset display blank or goes dark when on a call? What should I do when the handset does not turn on? [. . . ] View them using the following method. 1 K (centre of joystick) i j i M 2 Push the joystick down to search from the most recent call, or push the joystick up to search from the oldest call. ­7­ TG8301_8321FX(e)_QG. fm Page 8 Tuesday, April 1, 2008 11:06 AM Registering a handset to a base unit The supplied handset and base unit are pre-registered. If for some reason the handset is not registered to the base unit, register the handset. Handset 1 K (centre of joystick) i N i M 2 {V}/{^}: "Registration" i M 2 times 3 {V}/{^}: Select a base unit number. i M M Base unit Proceed with the operation for your model. [. . . ]