User manual PANASONIC KXTG8521E

[. . . ] TG8521E(e). book Page 1 Wednesday, March 17, 2010 3:39 PM Operating Instructions Digital Cordless Answering System Model No. KX-TG8521E KX-TG8522E KX-TG8523E KX-TG8524E Model shown is KX-TG8521. Before initial use, see "Getting Started" on page 9. Thank you for purchasing a Panasonic product. Please read these operating instructions before using the unit and save them for future reference. This unit is compatible with Caller ID and SMS. You must subscribe to the appropriate service offered by your service provider/telephone company. [. . . ] i t L All handsets registered to the base unit are displayed. L "Q" is displayed next to the selected handset numbers. 1 2 3 1 (centre of navigator key) i {#}{2}{1}{7} {V}/{^}: Select the desired entry. To edit a number: ~ i Edit the phone number. i M i {ic} To erase a number: 3 30 Helpline Tel. 01289 8333 TG8521E(e). book Page 31 Wednesday, March 17, 2010 3:39 PM Programming L To cancel a selected handset, press t again. Note: L Calls are disconnected when the handset moves from one radio cell to another. 4 5 6 M {V}/{^}: Select a memory location. iM Enter the phone number or area code to be restricted (8 digits max. ). i M i {ic} L To erase a restricted number, press ^. Registering a handset to a base unit The supplied handset and base unit are pre-registered. If for some reason the handset is not registered to the base unit (for example, _ is displayed even when the handset is near the base unit), reregister the handset. Note: L You can also select a memory location in step 5 as follows: Press {1} to {6}. i M 1 2 Handset: 1 (centre of navigator key) i {#}{1}{3}{0} {V}/{^}: Select a base unit number. iM L This number is used by the handset as a reference only. Base unit: Press and hold {x} for about 5 seconds, until the registration tone sounds. L If all registered handsets start ringing, press the same button to stop. L The next step must be completed within 90 seconds. Handset: Wait until "Base PIN" is displayed. i Enter the base unit PIN (default: "0000"). i M L If you forget your PIN, see page 52. L When the handset has been registered successfully, w is displayed. Registering a unit Operating additional units Additional handsets Up to 6 handsets can be registered to a single base unit. Important: L The additional handset model recommended for use with this unit is noted on page 4. If another handset model is used, certain operations (handset settings, base unit settings, etc. ) may not be available. Additional base units Handsets can be registered to up to 4 base units, allowing you to add additional base units and extend the area in which your handset(s) can be used. If a handset moves out of range of its base unit when "Auto" is selected on base unit (page 32), it looks for another base unit to make or receive calls. [. . . ] If the unit does not work properly, contact an authorised service centre. Caution: L To avoid permanent damage, do not use a microwave oven to speed up the drying process. 56 Helpline Tel. 01289 8333 TG8521E(e). book Page 57 Wednesday, March 17, 2010 3:39 PM Useful Information Belt clip To attach To remove Wall mounting Note: L Make sure that the wall is strong enough to support the weight of the unit. Base unit Charger 25 mm 57 mm Screws (Not supplied) Screws (Not supplied) Hooks Hook Helpline Tel. 01289 8333 57 TG8521E(e). book Page 58 Wednesday, March 17, 2010 3:39 PM Useful Information Conditions of guarantee This guarantee is in addition to and does not in any way affect any statutory or other rights of consumer purchasers. [. . . ]