User manual PANASONIC KXTGA750

[. . . ] This unit is an additional handset compatible with the following series of Panasonic Digital Cordless Phone: KX-TG4011/KX-TG4021/KX-TG4031/KX-TG4051/ KX-TG6511/KX-TG6521/KX-TG6531/KX-TG6541/ KX-TG7531 You must register this handset with your base unit before it can be used. This installation manual describes only the steps needed to register and begin using the handset. Please read the base unit's operating instructions for further details. Charge the batteries for about 7 hours before initial use. [. . . ] 2 Press {EDIT} repeatedly until the phone number is shown in the L To edit the number, press {EDIT} repeatedly until the phone number is shown in the desired format. Transferring calls, conference calls 1 During an outside call, press {INT} to put the call on hold. L If the paged party does not answer, press {C} to return to the outside call. L To put the outside call on hold, press {HOLD}. Alarm An alarm sounds at the set time for 3 minutes once or daily. L When you select "Once", enter the desired month and date. I {OK} L When you select "Off", go to step 5. Note: L To stop the alarm, press any dial key or place the handset on the base unit or charger. Silent mode Silent mode allows you to select a period of time during which the handset will not ring for outside calls. important: L Set the date and time beforehand (page 6). L We recommend turning the base unit ringer off in addition to turning the silent mode on. (KX-TG4021 series) L If you have set the alarm, the alarm sounds even if the silent mode is turned on. Enter the desired hour and minute you wish to start this feature. {AM/PM}: Select "AM" or "PM". I {OK} Enter the desired hour and minute you wish to end this feature. Voice mail service: Storing the voice mail (VM) access number Once you have stored your service provider/telephone company's voice mail access number, you can dial it automatically to listen to your voice mail messages. You need to store the voice mail access number to activate the message alert feature (page 13) for voice mail service. 1 {MENU} i {#}{3}{3}{1} 2 Enter your access number (24 digits max. Note: L When storing your voice mail access number and your mailbox password, press {PAUSE} to add pauses between the access number and the password as necessary. Contact your service provider/ telephone company for the required pause time. L To erase the voice mail access number: Press and hold {CLEAR} until all digits are erased in step 2. I {SAVE} i {OFF} Voice mail service: Voice mail (VM) tone detection Your service provider/telephone company sends special signals (sometimes called "voice mail tones" or "stutter tones") to the unit to let you know you have new voice mail messages after you press {C}. [. . . ] l Do not open or mutilate the batteries. Released electrolyte from the batteries is corrosive and may cause burns or injury to the eyes or skin. Do not allow conductive materials such as rings, bracelets, or keys to touch the batteries, otherwise a short circuit may cause the batteries and/or the conductive material to overheat and cause burns. L Charge the batteries provided with or identified for use with this product only, in accordance with the instructions and limitations specified in this manual. [. . . ]