User manual PANASONIC MC-E738

[. . . ] Tube Connect the tube to the handgrip by pressing the spring-loaded lock button on the handgrip and inserting the handgrip into the tube. Fit the spring-loaded lock button into the opening in the tube ("click") (fig. To disconnect the tube from the handgrip, press the spring-loaded lock button and pull the handgrip out of the tube. Use the same method to connect and disconnect the other accessories. [. . . ] Turn the tube 90 degrees anticlockwise until the nozzle is positioned lengthwise with the brush strip still folded out of the nozzle housing (fig. 3 With the nozzle positioned breadthwise and the brush strip folded in, you can vacuum clean large soft floor areas. Turn the tube 90 degrees anticlockwise again to position the nozzle breadthwise and to make the brush strip disappear into the nozzle housing (fig. 4 With the nozzle positioned lengthwise and the brush strip folded in, you can vacuum clean small soft floor areas. Turn the tube 90 degrees anticlockwise again until the nozzle is positioned lengthwise with the brush strip still folded in (fig. Crevice tool, small nozzle and small brush 1 Connect the crevice tool, the small nozzle or the small brush directly to the handgrip or to the tube (fig. Accessory holder 1 The accessory holder can simply be snapped onto the handgrip (fig. There are two ways to store accessories in the accessory holder. The crevice tool and small nozzle can be stored in the accessory holder by pushing them into the holder. To detach them, pull them out of the holder (fig. Please note the way in which the small nozzle must be placed in the accessory holder. Use minimum power for vacuum cleaning curtains, table carpets, etc. Parking the tube 1 Place the ridge on the nozzle in the parking slot to park the tube in a convenient position when you want to stop vacuum cleaning for a short while (fig. 2 Remove the mains plug from the wall socket. Cleaning and replacement Dustbags 1 Replace the dustbag as soon as the dustbag-full indicator changes colour (even when the nozzle is not placed on the floor) (fig. Make sure you hold the dustbag upright when lifting it out of the appliance. When you do this, the dustbag will be automatically sealed. 6 Slide the cardboard tag of the new dustbag into the two grooves of the dustbag holder as far as possible. You cannot close the cover if no dustbag has been inserted. If provided, you can use the cotton dustbag instead of paper dustbags. The cotton dustbag can be used and emptied repeatedly. - Close the dustbag by sliding the clip back onto the bottom edge of the dustbag. [. . . ] Ordering accessories If you have any difficulties obtaining dustbags, filters or other accessories for this appliance, please contact the Philips Customer Care Centre in your country or consult the worldwide guarantee leaflet. Ordering dustbags - Philips S-bag paper dustbags are available under type number FC8021. - Philips cotton dustbags are available under number 432200493290. Ordering filters - AFS Micro Filters are available under type number FC8030. [. . . ]