User manual PANASONIC PT-ST10U

[. . . ] · Use LAN cable that is compatible with category 5 or above. Check 2 Wired LAN settings <Computer with a built-in wired LAN function> · Is your wired LAN switched on?<Computer without a built-in wired LAN function> · Is your wired LAN adapter properly recognized?· Is your wired LAN adapter switched on?· Install the wired LAN adapter driver beforehand. [. . . ] There is a problem with the exhaust temperature sensor. For further detail, see the Basic Manual. 11 Using WebBrowser (cont. ) Projector control window You can make various projector settings. If you migrate from other page, click [Projector control] in the main menu (at the left of the window). Basic control window On this window, click the [Basic control] tab. Advanced control window On this window, click the [Advanced control] tab. Connection with the projector may not be possible immediately after the power is turned on. In this case wait a bit and then make the connection again. Detailed set up window Network config You can make detailed wired LAN settings. 1 2 Click [Detailed set up] [Network config] in the menu. Confirm the notes that appear on the screen and click [Next]. · To change the LAN settings, click [Change]. · To return to the previous window, click [Back]. The settings window appears, showing the current settings. 12 Using WebBrowser (cont. ) 3 Complete the detailed settings and click [Next]. When [Next] is clicked, the next page appears, enabling you to complete the detailed settings as desired. After all required items have been entered, a confirmation window appears. 4 Click [Submit]. The settings will be registered. If you have changed the LAN settings that are currently in use, the connection may break off. Adjust clock Click [Detailed set up] [Adjust clock] in the menu. Time zone : Select the time zone and click [Set time zone]. Time : Enter the current date and time in [Date] and [Time], and then click [Set date and time]. 13 Using WebBrowser (cont. ) E-mail set up You can specify two email recipients. Click [Detailed set up] [E-mail set up] in the menu. · [MAIL SERVER] · [MAIL OPTION] MAIL FROM : MEMO : ENABLE : Enable or disable email transmission. SMTP SERVER NAME : Enter the SMTP server name. Enter a description of the sender. · [TEMPERATURE WARNING SET UP] MINIMUM TIME : Enter the interval for sending email. INPUT AIR TEMPERATURE : Select the temperature of the intake sensor at which to send a warning message. Enter the email addresses of the recipients. When sending messages to mobile phones, select "SIMPLE". ERROR : Select ON to send email when errors occur. LAMP RUNTIME : Select ON to send email when "at REMAIN" is reached. INPUT AIR TEMPERATURE : Select ON to send email when the temperature set in [TEMPERATURE WARNING SET UP] is exceeded. PERIODIC REPORT : Send a message with the projector status at the selected date and time. E-MAIL ADDRESS : MAIL CONTENTS : · [E-MAIL ADDRESS] When [submit] is clicked, the settings are applied. Consult your system administrator on MAIL SERVER and E-MAIL ADDRESS settings. Ping test You can confirm if a network connection is established with Mail server, POP server, DNS server or the like. Click [Detailed set up] [Ping test] in the menu. [. . . ] is assigned to each and every network adapter around the world. These IDs are used to exchange data between adapters. These IDs are a combination of a discrete number managed and assigned by the IEEE to each individual manufacturer and a unique number assigned to each individual adapter by the manufacturer. Page 4 6 IP address 6 Subnetmask 6 Default Gateway 6 MAC address 8 Trademarks · Microsoft ® and its logo are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or · PJLink is a pending trademark in Japan, the United States and other countries and regions. [. . . ]