User manual PANASONIC SB-TP100

[. . . ] Before connecting, operating or adjusting this product, please read the instructions completely. Please keep this manual for future reference. For optimum performance and safety, please read these instructions carefully. DATE OF PURCHASE DEALER NAME DEALER ADDRESS TELEPHONE NUMBER The model number and serial number of this product can be found on either the back or the bottom of the unit. [. . . ] ( page 6) Be sure to spread a cloth, for example, on the floor to protect it from damage. Fit the bottom cover (provided) into the lower end of the speaker unit. Bring the cable out from the side of the bottom cover, and then insert the bottom cover. Fit the bottom cover into the speaker unit. Apply the spacers to the two points beneath the cover as shown in the illustration. When the screws are in this position, the speaker may drop off. Fit the speaker securely so the screws are in this position. Screw (not included) Screw the wood screw into a thick and hard part of the wall. The surface must be able to support over 25 kg (55 lb. Remove the upper and lower covers from the back Of the speaker unit, and remove the two stopper screws from the lower cover. Unless wall-mounting the speaker, do not remove the stopper screws. Return the speaker to the original condition by carrying out the opposite procedure to the above. Insert the stopper screws of step 2 above into the holes in the speaker unit. Fit the stand onto the speaker unit, and fix it in Push the stand to the rear of the bottom part of the speaker unit. Tighten the screws alternately and finally tighten them hard. Do not apply an unreasonable force to the net at the front of the speaker unit. Lay the speakers on a flat surface over a soft cloth when working on them. Be sure to connect only positive (copper) wire to positive (+) terminal and negative (silver) wire to negative (­) terminal. Press the spring lever to open the wire inlet, then insert the lead before releasing the spring lever. Attach the rubber feet to the base of the speaker to prevent vibration from causing the speaker to move or fall over. Screw (not included) Screw the wood screw into a thick and hard part of the wall. The surface must be able to support over 10 kg (22 lb. [. . . ] If a problem with this product develops during or after the warranty period, you may contact your dealer or Servicenter. If the problem is not handled to your satisfaction, then write to the warrantor's Consumer Affairs Department at the addresses listed for the warrantor. Ninety (90) days Ten (10) days Ninety (90) days During the "Labor" warranty period there will be no charge for labor. During the "Parts" warranty period, there will be no charge for parts. [. . . ]