User manual PANASONIC SC-ALL8GN

[. . . ] Before connecting, operating or adjusting this product, please read these instructions completely. Please keep this manual for future reference. E EB EE GN RQT6713-2B Table of contents Dear customer Thank you for purchasing this product. For optimum performance and safety, please read these instructions carefully. These operating instructions are applicable to the following systems. [. . . ] 11, 12 Remote control This illustration is of SC-AK310. SLEEP CLOCK AUTO OFF TIMER UTO PLAY PL REC Buttons such as 2 function in exactly the same way as the buttons on the main unit. DISC 1 PROGRAM 2 5 8 0 CD 3 6 9 10 4 S. SOUND EQ 7 PRESET EQ \ Sleep timer/auto off button (SLEEP, ­AUTO OFF) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13, 14 ; Disc button (DISC) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Program button (PROGRAM) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 , Muting button (MUTING) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 . SC-AK310 SC-AK110 CD display button (CD DISP) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 SC-AK210 TUNER BAND TAPE AUX VOL MUTING REW CLEAR VOL FF / _ + { } CD display/RDS display button (CD/RDS DISP) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8, 10 Dimmer button (DIMMER) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Play timer/record timer button (rPLAY/REC) . . . . . . . . . 14 Clock/timer button (CLOCK/TIMER) . . . . . . . . . . . . . . . . . . 13, 14 Numbered buttons (X10, 1­9, 0) . . . . . . . . . . . . . . . . . . . . . . . . . . 9, 10 X Play mode select button (PLAY MODE) . . . . . . . . 9, 10, 12 CD DISP DIMMER PLAY MODE 7 RQT6713 CDs CD selection Choose CDs with this mark: 1·2 3 SLEEP CLOCK AUTO OFF TIMER UTO PLAY PL REC DISC 1 PROGRAM 2 5 8 0 CD 3 6 9 10 4 S. SOUND EQ 7 PRESET EQ TUNER BAND TAPE Do not: AUX SC-AK310 VOL FF VOL MUTING REW CLEAR · · · · To prevent damage Always observe the following points: · Load only 1 CD on the tray. · Load CDs as shown in the figure. An adaptor is not needed with 8 cm CDs (singles). XX XX X XX XXXX XX X XX XXXX XX XX XX XX X XX X XX XX X XX XX XX XX XX XX X XX XX XX X XX XXXX XX 8 cm CD XXXXXX XXX XXXXXXX XXXX XX XXXXX XXXXXXX XXX XXXXXX XXXXX XX XXXX XXXX XX XXXXX XXXX XXXX XXXXX XXXX XX XXXXX XXXX XXXX XXXXX XXXXX XX XXXX XXXXX XXXX XXXX XXXXX XX XXXX XXXXX XXXX XXXX 12 cm CD · · · · · · · Set the system on a flat, level surface. Note You cannot use this function with 1-RANDOM or A-RANDOM mode. 1 Press [PLAY MODE] to select the desired mode. Every time you press the button: ALL-DISC 1-SONG 1-RANDOM 1-DISC A-RANDOM Program play You can program up to 24 tracks. Remote control only Preparation: Press [ :/J, CD] and then [L, CLEAR]. J 1 Press [PROGRAM]. "PGM" appears. Plays all loaded discs in succession from the selected disc to the final disc . 1-SONG: Plays one selected track on the selected disc. 1-RANDOM: Plays one selected disc in random order. A-RANDOM: Plays all loaded discs in random order. (The original display is restored in about 2 seconds. ) Proceed to step 4 when you selected A-RANDOM in step 1. ALL-DISC: 2 Press [DISC] and (within 10 seconds) [1]­[5] to select the disc. 2 Press [DISC] and (within 10 seconds) [1]­[5] to select the disc. The CD starts. 3 Select the tracks with the numbered buttons. To select track 10 or over, press [X10] then the two digits. Repeat steps 2 and 3 to program other tracks. 3 Only when you selected "1-SONG" in step 1 4 Press [:/J, CD] to start play. To exit program mode Press [PROGRAM] in the stop mode. (You can replay your program by pressing [PROGRAM] then [:/J, CD]. ) To cancel Press [L, CLEAR] in the stop mode. To check program contents Press [g, REW/3] or [f, 4/FF] while "P" is displayed. Every time you press the button, the track number and program order are displayed. To add to the program Do steps 2 and 3 while "P" is displayed. [. . . ] The stereo indicator flickers or doesn't light. A low hum is heard during AM broadcasts. @ Turn the TV off or separate it from the unit. Separate the antenna from other cables and cords. When there is a television set nearby The picture on the TV disappears or stripes appear on the screen. [. . . ]