User manual PANASONIC SCNE1EG

[. . . ] SC-NE1 Thank you for purchasing this product. Please read these instructions carefully before using this product, and save this manual for future use. Included Installation Instructions (l 2, 12–13) The installation work should be done by a qualified installation specialist. Before commencing work, carefully read these installation instructions and the operating instructions to ensure that installation is performed correctly. [. . . ] Bluetooth® input level If the sound input level of the Bluetooth® transmission is too low, change the input level setting. preparation ≥ Connect a Bluetooth® device. Connecting a paired Bluetooth® device Preparation ≥ Turn on the Bluetooth® feature of the device and place the device near this unit. ‰ If this unit is already connected to a Bluetooth® device, disconnect it. 1 2 Press [PLAY MENU] repeatedly to select “INPUT LEVEL”. Press [3, 4] to select the level and then press [OK]. The name of the connected device is indicated on the display for 2 seconds. Start play on the Bluetooth® device. disconnecting a Bluetooth® device ≥ This unit can only be connected to one device at a time. ‰ When “BLUETOOTH” is selected as the source, this unit will automatically try and connect to the last connected Bluetooth® device. Book 7 ページ ２０１３年１月１５日　火曜日　午後１時４分 Sound adjustment The following sound effects can be added to the audio output. 1 2 Press [SOUND] repeatedly to select the effect. Press [3, 4] to select the setting and then press [OK]. *1: This function can also be selected with the [D. ‰ You may experience a reduction in sound quality when these effects are used with some sources. If this occurs, turn the sound effects off. Book 8 ページ ２０１３年１月１５日　火曜日　午後１時４分 Others Sleep timer The sleep timer can turn the unit off after a set time. Changing the unit and remote control code When other Panasonic equipment responds to the supplied remote control, change the remote control code. 1 2 Press [SETUP] to select “SLEEP”. Press [3, 4] to set the time (in minutes) and then press [OK]. ‰ The remaining time is indicated on the unit’s display except when other operations are performed. While pressing and holding [ / AUX] on the unit, press and hold [SOUND] on the remote control until the unit’s display shows “REMOTE 2”. [. . . ] ‰ Keep the safety holder out of reach of children to prevent swallowing. ‰ Keep the screws out of reach of children to prevent swallowing. ‰ Keep the wall mount brackets out of reach of children to prevent swallowing. 1 Measure and mark the position of the wall mount brackets (Both sides). [. . . ]