User manual PANASONIC SC-PM250GN

[. . . ] These operating instructions are applicable to the following system. Table of contents Before use Supplied accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Safety precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Caution for AC Mains Lead . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . The remote control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 2 Press [PGM] then press [g 4/REW] or [f 3 /FF] to select a channel. 3 Press [PGM]. Pre-set the stations one at a time. The station occupying a channel is erased if another station is preset in that channel. B Selecting channels Press the numeric buttons to select the channel. For channels 1 to 9, press the corresponding number. For channels 10 to 15, press [ 10], then the two digits. 1 1 4 7 2 5 8 0 3 6 9 10 1 1 2 Preset channel OR Press [PLAY MODE] to select "PRESET". Press [g 4/REW] or [f 3 /FF] to select the channel. 2 Adjust the volume. 2 VOL VOL RQT6686 Listening operations PGM Do the following once each for FM and AM. Preparation: Tune to the frequency where pre-setting is to begin (\ page 10). 11 CDs This unit can play CD-DA (digital audio) format audio CD-R and CD-RW that have been finalized (a process that enables CD-R/CD-RW players to play audio CD-R and CD-RW) upon completion of recording. It may not be able to play some CD-R or CD-RW due to the condition of the recording. You can simply listen to the CD on a single tray, or you can select and listen to the CD in a particular tray. See the section on All-Disc play (\ page 14) for information on how to listen to all the CDs one after the next. STOP , DEMO /FF, /REW (CD 1) ~ (CD 5) 2 3 1 Listening to the CD on a single tray 1 Listening operations OPEN/CLOSE 1 2 3 Press [c OPEN/CLOSE] to open the disc tray and insert the CD. The unit comes on automatically and tray 1 opens. Press [c OPEN/CLOSE] again to close the tray. Press [CD 2/ J] to start play. The selected CD is played from the first track to the last track in order. After the last track, the player stops automatically. Adjust the volume. Label must face upward. To stop the disc Press [STOP L, ­DEMO]. · Do not remove or insert CDs during a CD check. · Do not pull out the trays during a CD check. CD indicator Track number Elapsed playing time 4 VOLUME DOWN UP A CD CHECK CD CHECK RQT6686 Listening operations Press [c CD CHANGE] again to close the tray. Repeat steps 1 and 2 to insert other CDs. You can load up to 5 CDs. 13 CLOCK SLEEP AUTO OFF TIMER UTO PLAY PL REC CDs 3 2 1 DISC 1 4 7 PLAY PLAY MODE PGM 2 5 8 0 3 6 9 10 4 15 Listening to specific CDs and tracks (CD Play Mode function) By remote control only This function makes it easier for you to select specific CDs and tracks from those loaded in the player. All-Disc mode : Plays all loaded discs in succession from the selected disc to the final disc . 1-Disc Random mode : Plays one selected disc in random order. All-Disc Random mode : Plays all loaded discs in random order. 1-Disc mode : Plays one selected disc. CD TUNER/ BAND CLEAR TAPE APE AUX VOL MUTING S. SOUND EQ PRESET EQ REW DISPLAY DISPLA VOL FF DIMMER 1 Listening operations CD CLEAR 1 2 Press [CD 2/J] and then [L CLEAR]. Press [PLAY MODE] to select the desired mode. Every time you press the button: 2 PLAY MODE ALL-DISC 1-RANDOM 1-DISC A-RANDOM ALL-DISC : All-Disc mode 1-RANDOM : 1-Disc Random mode A-RANDOM : All-Disc Random mode 1-DISC : 1-Disc mode (The original display is restored in about 2 seconds. ) Note Proceed to step 5 if A-RANDOM was selected in this step. 3 4 Press [DISC]. (Within 10 seconds) Press [1]-[5] to select the disc. The CD starts if 1-DISC, ALL-DISC or 1-RANDOM was selected in step 2. 3 4 Note DISC Step 5 is not required if 1-DISC, ALL-DISC or 1-RANDOM was selected in step 2. 5 1 4 2 5 3 Press [CD 2/ J]. The CD starts. To stop play Press [L CLEAR]. When playback ends The current play mode will be retained. Specified CD indicator Final disc For example, if play starts from disc 4, disc 3 will be the "final disc". [. . . ] 0. 7 W AM TUNER SECTION Frequency range 522 ­ 1629 kHz (9 kHz steps) 520 ­ 1630 kHz (10 kHz steps) Sensitivity S/N 20 dB (at 999 kHz) 560 µV/m Notes 1. Specifications are subject to change without notice. Total harmonic distortion is measured by the digital spectrum analyzer. The labels "HIGH (HF)" and "LOW (LF)" on the rear of the speakers refer to High frequency and Low frequency. Maintenance If the surfaces are dirty To clean this unit, wipe with a soft, dry cloth. [. . . ]