User manual PANASONIC SL1200GAEEG

[. . . ] SL-1200GAE Operating Instructions Bedienungsanleitung Mode d’emploi Istruzioni per l’uso Instrucciones de funcionamiento Gebruiksaanwijzing Bruksanvisning Betjeningsvejledning Käyttöohjeet Instrukcja obsługi Návod k obsluze Direct Drive Turntable System Plattenspieler mit Direktantrieb Platine vinyle à entraînement direct Giradischi ad azionamento diretto Sistema de accionamiento directo del plato giratorio Platenspeler met directe aandrijving Skivspelare med direktdrivning Pladespiller med direkte drev Suoravetoinen levysoitinjärjestelmä Gramofon Direct Drive Gramofonový systém s přímým pohonem Music is borderless and timeless, touching people’s hearts across cultures and generations. Each day the discovery of a truly emotive experience from an unencountered sound awaits. Let us take you on your journey to rediscover music. (2) English Delivering the Ultimate Emotive Musical Experience to All At Technics we understand that the listening experience is not purely about technology but the magical and emotional relationship between people and music. We want people to experience music as it was originally intended and enable them to feel the emotional impact that enthuses and delights them. [. . . ] zz Tighten the three screws evenly. Auxiliary weight To „„ remove the turntable and remove them. - eep the screws, belleville springs, and K washers carefully. k  old the turntable with both hands and H slowly pull it straight up. L   oosen the mounting screws for turntable zz Attach the included auxiliary weight to the rear of the tone arm according to the weight of your cartridge. For adjustable cartridge weight ranges, see "Applicable cartridge weight range". (25) Note zz The inside of the balance weight is greased. Fitting the turntable mat 4 Lay the turntable mat on the turntable. 0 0 13 English (13) Connections and installation zz Turn off all units and disconnect the AC mains lead from the socket before making any connections. zz Connect the AC mains lead only after all other connections are completed. zz Be sure to connect the PHONO earth lead. zz Refer also to the instruction manual of the connected device. 1 Connect the PHONO cables and PHONO earth lead to the PHONO terminals of the connected equipment. zz You will not have adequate volume or sound quality if the connected amplifier has no PHONO terminals. 2 Connect the AC mains lead. zz Confirm the wattage of the AC outlet on the connected equipment before using it for this unit. (This unit consumes 14 W. ) Connecting to an integrated amplifier or component system Amplifier (not included) Back of main unit VOLUME INPUT SELECTOR PHONES 5V 2. 1A PHONO EARTH PHONO R R L L Insert the AC mains lead up to a point just before the round hole. PHONO cable PHONO earth lead To a household mains socket Note zz The operation switch does not separate entire unit from mains even if in “OFF“ position. Remove the plug from the mains socket if you will not be using the unit for an extended period of time. Place the unit so that the plug can be easily removed. 14 (14) English Installation Install the unit on a horizontal surface protected from vibrations. Keep this unit as far as possible from speakers. Notes for installation „„ Adjusting the height to make the „„ unit horizontal Raise the main unit to turn the insulators and adjust the height. zz Anti-clockwise: Increases the height. Attention zz Do not turn the insulators too far. Doing so may cause them to come off or damage them. zz Before you move the unit, remove all devices connected and turn off the power supply. zz Ensure the unit is not exposed to direct sunlight, dust, humidity, and heat from a heating appliance. zz This unit may pick up interference from a radio if there is one nearby. Keep the unit as far as possible from a radio. zz Do not install the unit on a heat source. zz Avoid a place with large temperature variations. zz Avoid a place with frequent condensation. [. . . ] Sound is weak. zz Are connections to the amplifier/receiver’s PHONO terminals correct?Connect the PHONO cables to the amplifier’s PHONO terminals. ( 14) 1 Turn [ON/OFF] to OFF and remove the turntable. ( 13) 2 Connect the USB memory for Left and right sounds are reversed. zz Are the stereo connection cable connections to the amplifier or receiver reversed? [. . . ]