User manual PANASONIC SUG700E

[. . . ] Through delivering this experience we want to support the development and enjoyment of the world’s many musical cultures. With a combination of our love of music and the vast highend audio experience of the Technics team, we stand committed to building a brand that provides the ultimate emotive musical experience by music lovers, for music lovers. Director Michiko Ogawa 05 Thank you for purchasing this product. Please read these instructions carefully before using this product, and save this manual for future use. [. . . ] Using analogue audio cable 1 Disconnect the AC mains lead. 2 Connect this unit and AV receiver , control amplifier , etc. After minimising the volume of the device. 3 Connect the AC mains lead to this unit. €¢ You can also select the input source by turning the input selector knob on the unit. Note • It is not possible to adjust the volume with this unit. €¢ Sound is not output from headphones jack and PRE OUT terminals. €¢ Select “LINE2” when not using this unit as power amplifier. ( 19) • When the input source is switched to “LINE2” or other source from “MAIN IN” and the current volume level is higher than previous level, the volume is automatically adjusted. Minimising sound distortion If sound distortion occurs, setting the attenuator to “On” may improve the sound quality. You can connect the power amplifier, subwoofer, etc. €¢ The choppy audio occurs in output audio signal when switching the input source. Operations (23) 23 English Settings Sound adjustment, Other settings The sound effects and other settings can be set up. 3 Press [ ], [ ] repeatedly to select the menu and then press [OK]. 4 Press [ ] , [ ] , [ ] , [ ] to select a desired item or value , and press [OK]. Adjusting BASS/MID/TREBLE “Tone Control” You can adjust the tone of this unit. Each tonal range (BASS/MID/TREBLE) can be adjusted. • To enable this function , select “On (adjustment)”. €¢ Each level can be adjusted between “-10” and “+10”. ) to this unit, sound setting on the connected device may have a priority over this unit. Adjust the sound with the connected device. €¢ Not available when using this unit as power amplifier ( 20). [. . . ] Select ”Attenuator” according to the selected analogue audio input, and change the setting of the attenuator to “On”. ( 19) Unlocked • “COAX1” , “COAX2” , “OPT1” , “OPT2” or “PC” is selected , but no device is connected. ( 16 , 17) • The sampling frequency components , etc. Of the audio signals are not input correctly. [. . . ]