User manual PANASONIC TX29P250T

[. . . ] TV sets can produce static electricity, care must be taken whenever touching the TV screen. Adequate ventilation is essential to prevent failure of electrical components. We recommend that a gap of at least 5cm is left all around this TV even when it is placed inside a cabinet or between shelves. D D D D D D D FOR YOUR SAFETY PLEASE READ THE FOLLOWING CAREFULLY This appliance is supplied with a fitted three pin mains plug for your safety and convenience. If the fuse is replaced then the replacement fuse must be 5 amp rated and should be approved by ASTA or BSI to BS1362. Check for the ASTA mark or the BSI mark on the body of the fuse. If the fitted plug has a removable fuse cover you must ensure that it is refitted when the fuse is replaced. [. . . ] If in any doubt please consult a qualified electrician. How to replace the fuse : Lift out the removable fuse compartment with a screwdriver and replace the fuse, then refit securely into the mains plug. Important Note : The layout of the mains plug used may differ from this illustration. IMPORTANT :--- The wires in the mains lead of this appliance are coloured in accordance with the following code :--BLUE : NEUTRAL BROWN : LIVE As the colours of the wires in the mains lead of this appliance may not correspond to the markings identifying the terminals in your plug, proceed as follows :--1. The BLUE wire must be connected to the terminal marked `N' or coloured black. The BROWN wire must be connected to the terminal marked `L' or coloured red. IMPORTANT NOTE : Under no circumstances should either of these wires be connected to the Earth terminal of the three pin plug, marked with the letter `E' or the earth symbol ( ). 3 ACCESSORIES Check that you have the accessories and items shown Remote Control Transmitter EUR511300 Batteries for the Remote Control Transmitter. (2 x R6 (UM3) size) Operating Instruction book AV cover (TX---21JT1L only) TKK8E043 TV Guarantee Telescopic Aerial (TX---14JT1L only) TSA---120026 FITTING REMOTE CONTROL BATTERIES 1 2 3 Slide off the battery cover Insert batteries -- note correct polarity (+ and --) Replace the cover D Make sure that the batteries are fitted the correct way round. D Do not mix old batteries with new batteries. Remove old, exhausted batteries immediately. D Do not mix different battery types, i. e. Do not use rechargeable (Ni---Cad) batteries. 4 INSTALLATION AND SET---UP 1 Mains Socket TV only Connect Aerial co---axial cable direct to TV RF IN socket. OR Mains Socket USING A VCR Connect aerial co---axial cable to RF Input socket of VCR and a RF co---axial cable from VCR RF Out socket to TV RF IN socket. The VCR can also be connected to the TV using a SCART to SCART lead. VCR Further details of Audio/ Video connections can be found on page 11. OR USING A VCR AND SATELLITE RECEIVER Connect aerial co---axial cable to RF Input socket of Satellite Receiver. Swap If the programme order after Auto Setup is not to your preference you can swap programmes between positions. Main Menu Contrast Brightness Colour Sharpness C ---A ---T ---S Tuning Menu : Select ---/+ : Access N : Exit 1 CH21 Tuning Menu Auto Setup Manual Tuning Fine Tuning Swap : Select ---/+ : Access F : Previous Menu N : Exit 1 CH21 Swap Position with Position 01 07 CH44 CH58 ---/+ TV/AV F N : : : : : Select Adjust Swap Previous Menu Exit TELETEXT Auto Setup TV/AV : Start ATP F : Previous Menu N : Exit Manual Tuning (front panel of the television) The stations may also be manually tuned using the controls on the front of the television. Press the F key (Front panel) until "Manual Tuning" is reached. This TV is capable of switching to AV operation automatically if the equipment connected provides a switching signal to the SCART socket. In this condition the display will show EC and it is possible to change the programme position of the TV without changing the displayed picture (this is not possible when using the front AV connections). Video input to V socket Audio input to A socket Output from Headphone socket Input/Output from AV SCART Socket SCART Cable VCR RCA Video Cable RCA Audio Cable SATELLITE RECEIVER VCR Headphones with 3. 5mm jack plug CAMCORDER CAMCORDER COMPUTER (RGB) Ancillary equipment and cables shown are not supplied with this TV set. Do not connect a computer with TTL output (5V) to this TV set. The TV's speaker will be automatically disconnected whilst the headphones are connected. Do not connect front and rear AV inputs simultaneously, as the sound and pictures will be mixed. 11 VCR INSTALLATION Your new TV is supplied with programme position `0' designed specifically to receive an RF signal from a VCR. However, depending on the VCR's setting you may not receive any picture or sound from the VCR on programme position `0' of the TV. It will be necessary to either adjust the RF channel of the VCR or to adjust the tuning of the TV's programme position `0' or both until the RF output channel of the VCR is received. It is intended that this advice is used in conjunction with the instruction books for your ancillary equipment. TO TUNE YOUR VCR TO THE TV Insert recorded tape and select playback TO TUNE YOUR TV TO THE VCR Set TV to programme position `0' VCR Access the Manual tuning menu as detailed on page 9. Programme position and current channel are displayed top left of screen -- + To select programme position `0' To start search for VCR playback VCR CH32 Manual Tuning RF CHANNEL ADJUST : ---/+ : : : Programme Position Start Search . [. . . ] the setting at the time of switch off will be the setting used when the receiver is switched on again: Programme position Colour Volume Contrast Brightness Standby Sharpness Status C---A---T---S TV Games / Home Computers Extended use of TV games or home computers with any television set can cause a permanent `shadow' on the screen. This type of irreversible picture tube damage can be limited by observing the following points : D D Reduce the brightness and contrast levels to a minimum viewing level. Do not operate the television set for a continuous period of time while using TV games or home computers. This type of picture tube damage is not an operating defect and as such is not covered by the Panasonic warranty. 14 SPECIFICATIONS Model Number: Power Source: Power Consumption: Standby Power Consumption: Picture Tube: Audio Output (music) Dimensions: Weight: Receiving Systems: TX ---21JT1L 220---240V 50Hz A. C. 50W 1, 1W 51cm visible diagonal 476 (H) x 512 (W) x 470 (D) mm 20, 6 kg PAL I PAL 525/60 TX ---14JT1L 33W 34cm visible diagonal 352 (H) x 371 (W) x 371, 5 (D) mm 9, 5 kg 6W, 8 impedance, mono UHF E21---69, VHF A1---S20, S21---41 (Hyperband) Aerial (rear): Headphones (front): AV --- Rear: AV --- Front: Design and specifications are subject to change without notice. [. . . ]