User manual PANASONIC TYCE42PS20

[. . . ] Take steps to prevent the ceiling-hanging bracket from falling. Failure to carry out the installation completely may result in injury or even death. Do not use any plasma displays other than those given in the catalogue. Otherwise the unit may be dropped and become damaged, and personal injury may result. [. . . ] Ensure good air flow so that the ambient temperature does not exceed 40 °C (104 °F). Failure to do this may cause heat to build up inside the plasma display, resulting in malfunction. Spread a soft blanket or cloth over the floor so that the plasma display and floor will not be marked or scratched during the assembly and installation work. When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over tightened. Take sufficient care and ensure safety around you when performing the installation work. Otherwise, the cabinet may be bent or damaged by high heat. Check that all the parts are accounted for and present in their designated quantities. Refer to the instruction manual of the plasma display, and check the weight of the plasma display unit which will be fitted into the ceiling-hanging bracket. Refer to the outline drawing of the ceiling-hanging bracket shown on the right, and check the ceiling strength at the eight installation positions shown. If the strength at any of these positions is lacking, provide sufficient reinforcement. Prepare the ceiling unit remove the protective sheets (8 sheets) for the bracket of the ceiling unit at four locations. Set a spring washer on the rotation stop screw , and fix at the position show on the right. M) Remove the two M8 assembly bolts from the ceiling unit and separate the upper and lower sections of the unit. Use the removed M8 assembly bolts when attaching the ceiling unit (lower section). Align the screw holes, and secure with the removed screws. M8 assembly bolt Ceiling unit (lower section) Rotation stop screw Spring washer Before installing the upper section on the ceiling, pass the wiring through the pipe as shown in the figure on the right. Use an earthed extension cord for the power cord (not supplied). Pass the other device connection cables through the same way. Make holes for inserting M12 bolts on the ceiling using a method appropriate for the ceiling structure. install the upper section using a hex socket bolt (M12) (not supplied) , flat washer and spring washer. * Attach a ceiling cover to the ceiling board if needed using three truss tapping screws . Flat washer Spring washer M12 bolt Device connection cables Earthed power extension cord Ceiling cover Truss tapping screw Pass the cords and cables extending from the ceiling unit (upper section) through the pipe of the ceiling unit (lower section). [. . . ] Screw for securing unit (M5-35) Retirez les feuilles de protection (8 feuilles) du support Support plafond en quatre points du support de plafond. Engagez les cordons et les câbles provenant du support plafond (section supérieure) dans le tube du support plafond (section inférieure). Lorsque vous prenez des dispositions pour prévenir la chute du support, veillez à ce que le poids du support de suspension au plafond soit supporté. Pour assurer que les personnes se trouvant à proximité ne seront pas frappées par le support de suspension au plafond s'il glisse hors de position, utilisez au moins un câble métallique, en laissant un certain jeu, pour empêcher le support de tomber. [. . . ]