User manual PANASONIC TYST58PF20

[. . . ] Otherwise the unit may fall over and become damaged, and personal injury may result. Otherwise the unit may fall over or down, and personal injury may result. Otherwise the unit may fall over and become damaged, and personal injury may result. The casters may crack or became damaged, and the display may fall down and became damaged, and personal injury may result. [. . . ] Ensure good air flow so that the ambient temperature does not exceed 40 °C (104 °F). Failure to do this may cause heat to build up inside the plasma display, resulting in malfunction. Fit so there is no contact between the attachment bolts or power cord and any metal inside the wall. Spread a soft blanket or cloth over the floor so that the stand and floor will not be marked or scratched during the assembly and installation work. Perform the assembly and installation work on a flat and level surface, and follow the assembly and installation work instructions. When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over tightened. Take sufficient care to ensure safety around you when performing the assembly and installation work or while moving about during the course of the work. Be sure to read and observe the "Safety precautions". This stand is intended for only Panasonic plasma display models (See page 121). Base unit with casters (2) Base joint (1) Support column (left/right) (One for each side) Hexagon socket cap button bolt (M8 × 65) Spring washer/Flat washer Cap nut with flange (M8) (Four each) Hexagon socket cap button bolt (M8 × 70) Spring washer/Flat washer Cap nut with flange (M8) (Six each) Allen head countersunk screw Dished toothed washer Insulation spacer (Four each) Screw for securing unit (M4 × 16) (2) [The images shown in this manual are for illustrative purpose only. Check that all the parts are accounted for and present in their designated quantities. When assembling, make so the caps nut of the hexagon socket cap button bolts are on the inside of the stand. Face screw holes of base unit with casters to the rear and align with base joint as shown in Base joint the figure on the right, and fasten with the four Hexagon socket readied hexagon socket cap button bolts cap button bolt (M8 × 65) and cap nuts with flanges . Screw holes Face this side to the rear Face the "L" and "R" marks of support columns (left/ right) to the inside, and insert the bottom plates into the back side of the stand base from above. Temporarily secure support columns (left/right) with the readied four hexagon socket cap button bolts (M8 × 70) and cap nuts with flanges . Support column (left) Cap nut with flange (M8) Hexagon socket cap button bolt (M8 × 70) Support column (right) Adjust the support columns (left/right) so that they are perpendicular to the stand base. Tightly fasten the four hexagon socket cap button bolts that temporarily fixed the support columns. The attachment position differs according to the size ) Hang the tabs of the top bracket for plasma display to the cutouts for temporarily holding the bracket for plasma display located on the front of the left and right support columns. Fasten with four screws for attaching bracket for plasma display from the side. Hang the tabs of the bottom bracket for plasma display to the cutouts for temporarily holding the bracket for plasma display located on the front of the left and right support columns. Fasten with four screws for attaching bracket for plasma display from the side. Bottom bracket for plasma display Wood screw Align the positioning holes of the shelf plate with the bracket protrusions to position the two brackets for shelf plate , and attach them with four wood screws through the outside holes. [. . . ] * The details in this section indicate how to reduce any damage or injury caused by this equipment overturning or falling due to an earthquake. However, there is no guarantee that the overturn/fall prevention accessories will be effective in all earthquake situations. Remove the two screws for securing unit on the back of the top bracket for plasma display on the mobile stand. remove the cord or wire for preventing the unit from falling over. [. . . ]