User manual PANASONIC TYWK42PV20

[. . . ] Do not use any plasma displays other than those given in the catalogue. Otherwise the unit may be dropped and become damaged, and personal injury may result. Do not install the plasma display in any other way than the steps specified in these instructions. Otherwise the unit may be dropped and become damaged, and personal injury may result. [. . . ] 2 inches) that are suited to the wall material (wood, steel frame, concrete etc. Ensure good air flow so that the ambient temperature does not exceed 40 °C (104 °F). Failure to do this may cause heat to build up inside the plasma display, resulting in malfunction. Spread a soft blanket or cloth over the floor so that the plasma display and floor will not be marked or scratched during the assembly and installation work. When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over tightened. For the plasma display power supply plug, use a power supply outlet that can be reached easily. Take sufficient care and ensure safety around you when performing the installation work. Otherwise, the cabinet may be bent or damaged by high heat. Place the base upper and lower fittings and base left and right fittings as shown in the diagram. Insert the projecting parts (tabs) of the base left and right fittings into the cutouts of the base upper and lower fittings (two positions on right, and two on left), and secure the fittings with the screws for assembling the fixtures (two for each) in the order of and then . Please hold the bracket base left and right fittings as you work with the assembled wall hanging bracket. Holding the base upper and lower fittings might deform this unit. Refer to the instruction manual of the plasma display, and check the weight of the plasma display unit which will be fitted into the wall-hanging bracket. refer to the outline drawing of the wallhanging bracket shown on the right , and check the wall strength at the six installation positions shown. If the strength at any of these positions is lacking, provide sufficient reinforcement. notes · There are five pre-drilled mounting holes at the top and another five at the bottom of the wallhanging bracket. Use the spare holes provided if wood or some other material is used for the wall and a sufficient level of mounting strength cannot be ensured by anchoring the fixture at the six positions shown on the right. However, bear in mind that, depending on which materials the mounting surface is made of, cracks may form on the surface if the screws are used at positions which are too close together. Do not mount or place any other product other than the plasma display on the fixture. Wall mounting holes (at 6 points) Use the screws without fail to anchor the fixture. [. . . ] surface of wall Horizontal installation Left or right side of wall-hanging bracket Vertical installation Left side of wall-hanging bracket Note · Otherwise, the screw for securing unit may drop down by mistake, leaving marks on the surface of the floor. Disconnect the power cord and the wires connecting the plasma display to the other units. While lifting the bottom part of the plasma display, pull the plasma display toward you. After the bottom insulation spacers have been removed, continue lifting up the plasma display and remove it. [. . . ]