User manual PANASONIC VL-FKD2EX

[. . . ] ) R By installing this product, you can extend the range of your Video Intercom System to include areas where reception was previously not available. The product extends the range in all directions, allowing several floors to be covered. R You must register this product with your Video Intercom System before it can be used. R Keep an appropriate distance from the main monitor to maximise the range of your Video Intercom System. [. . . ] R Unplug the product from the power outlet if the product emits smoke, an abnormal smell or makes unusual noise, or if the product has been dropped or physically damaged. These conditions can cause fire or electric shock. Confirm that smoke has stopped emitting and contact an authorised service centre. R Hold the main body (not the metal parts) of the AC adaptor when unplugging it. Unplugging the AC adaptor while holding its cord or the cord’s plugs may result in fire, electric shock, or injury. Preventing accidents R Do not use the product in health care facilities if any regulations posted in the area instruct you not to do so. Hospitals or health care facilities may be using equipment that could be sensitive to external RF (radio frequency) energy. R Do not install or use this product near automatically controlled devices such as automatic doors and fire alarms. Radio waves emitted from this product may cause such devices to malfunction, resulting in an accident. R Consult the manufacturer of any personal medical devices, such as pacemakers or hearing aids, to determine if they are adequately shielded from external RF (radio frequency) energy. 90 GHz, and the RF transmission power is 250 mW (max. It should not be placed in rooms where the temperature is less than 0 °C or greater than 40 °C. R Do not install the product in locations that are suspect to sudden changes in temperature. Failure to do so may cause condensation to form on the product causing malfunction. R Even when the repeater and sub monitor (or camera) are used within 100 m of each other, obstructions can cause weak signals, noise, interrupted transmissions, distorted images and slow image refresh rates. Obstructions can include: – Metal doors or metal shutters. € If the sub monitor is being used in a different building, or a different part of the house, i. A different floor to the where the main monitor has been installed. R Operating the product near electrical appliances may cause interference. Move away from the electrical appliances. Other important information R The AC adaptor is used as the main disconnect device. Ensure that the power outlet is installed near the product and is easily accessible. [. . . ] Strong Indicates the signal level of the main monitor. R Determine the installation location of the repeater by checking the signal level shown with the indicator. Indicator ID indicator Lit green Lit orange Lit red Flashing red Weak Signals do not reach the repeater and it should not be installed in this location. ) 7 Installation/Registering the repeater to the main monitor 1 Repeater: Connect the AC adaptor, and plug the AC adaptor into a power outlet. [. . . ]