User manual PANASONIC VLV554FX

[. . . ] –■ Please read this guide carefully, and install the product safely and correctly by following the instructions. Carefully read the information found in the section titled "For your safety" in particular. –■ Only use attachments/accessories specified by the manufacturer. –■ The installation shall be carried out in accordance with all applicable installation rules. [. . . ] D ●● o not make any wiring connections when the power supply is turned on. D ●● o not directly spray the product with water from a hose or other objects. D ●● hen existing chime wires are used, it is possible that they contain AC voltage. w Contact an authorised service centre. Location of controls A Lens cover A D E B C F G B LED lights (for illumination) C Name plate (accessory) ●●Can be attached as required when installing the doorphone. D Microphone E Camera lens F Speaker G Call button and indicator (red) ●● he indicator lights in red when the T power is on. Front panel ●● ou can use the main monitor’s [Zoom position settings] setting to select the desired area visible Y when zooming. Refer to the following and configure the main monitor. *2  ater resistance is only assured if the doorphone is installed correctly according to the W instructions in this guide, and appropriate water protection measures are taken. Note: ●● esign and specifications are subject to change without notice. D ●● ames, company names, product names, software names, and logos mentioned in this N manual are trademarks or registered trademarks of the companies concerned. Information for Users on Collection and Disposal of Old Equipment and used Batteries A 3 Approx. Terminal for the main monitor <Rear view> Terminals for the electric locks ●● ecommended torque: R 0. Cm} CAUTION Preventing electric shock ●● f the wiring is underground, do not make any connections underground. I ●● f the wiring is underground, use a protection tube. I ●● f the wiring is outdoors, use a protection tube or a surge protector. 85° Preventing injury ●● nstall the product securely adhering to the instructions in this guide to prevent it from I falling off the wall. Avoid installing onto low-strength walls, such as gypsum board, ALC (autoclaved lightweight concrete), concrete block, or veneer (less than 18 mm thick) walls. For your future reference We recommend keeping a record of the following information to assist with any repair under warranty. (found on the rear of the product) Name and address of dealer Attach your purchase receipt here. Date of purchase ■■ Doorphone image quality The following phenomena may occur. —● If strong light such as sunlight shines into the camera lens, uneven colouring from reflected light, or white lines or circles may appear in images. [. . . ] In this case it complies with the requirement set by the Directive for the chemical involved. A ttach the name plate to the doorphone and use screw A to secure the front panel. —● Write the name on the name plate as needed. Cleaning Image displayed on main monitor: Clean the product with a soft, dry cloth when cleaning. [. . . ]