User manual PANASONIC WH-SDH09C0E8

[. . . ] NOTICE : When the outdoor temperature is out of the above temperature range, the heating capacity will drop significantly and outdoor unit might stop for protection control. INDOOR UNIT AND OUTDOOR UNIT This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Do not install the unit in a potentially explosive or flammable atmosphere. [. . . ] Do not wash the control panel with water, benzene, thinner or scouring powder. Otherwise, it may cause injury if mishandling. Some functions described in this manual may not be applicable to your unit. Consult your nearest authorized dealer for further information. Open the cover to use the buttons The current day and time need to be set when: - The power is turned on for the first time. - After a long time has elapsed since the power was last turned on. When unit is ON, operation LED is lit and the actual temperature for water outlet and outdoor ambient are shown on the control panel display. This operation reduces outdoor unit noise. In this condition, it may cause decrease in heating capacity. STATUS mode cannot be activated when the "SETTING" indicator is ON. Using the control panel could set the temperature range for water outlet temperature and outdoor ambient temperature. For 5 seconds to enter "SETTING" mode. After selecting the desired parameter, to enter the parameter. Repeat steps 2 to 5 to set other parameters. Or wait 30 seconds to exit "SETTING" mode. "SETTING" mode cannot be activated when the "PUMPDW" and "STATUS" indicator is ON. Timer Display Lights up if Timer operation is selected 6 different programs can be set in a day (1 ~ 6) Indicates the selected day Indicates the next timer operation day Time to be selected (10 minutes step) OFF Timer ON Timer To automatically switch "OFF" the unit To automatically switch "ON" the unit Day to be selected Function Enter timer mode Set day & time Step Press The selected day will be highlighted with . After 2 seconds, the display will move to the next program. During timer setup, if no button is pressed within 30 seconds, or if the button is pressed the setting at that moment is confirmed and timer setup is ended. Until your desired day is shown, press to check the set programs. You can set the Timer for each day of the week (Monday to Sunday) with 6 programs per day. When the unit is switched on by the ON TIMER, it will use the previously set temperature to control the room temperature. [. . . ] For proper treatment, recovery and recycling of old products, please take them to applicable collection points, in accordance with your national legislation and the Directives 2002/96/EC and 2006/66/EC. By disposing of these products correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. For more information about collection and recycling of old products, please contact your local municipality, your waste disposal service or the point of sale where you purchased the items. Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation. [. . . ]