User manual PANASONIC WHUD09CE5

[. . . ] NOTICE : When the outdoor temperature is out of the above temperature range, the heating capacity will drop significantly and outdoor unit might stop for protection control. INDOOR UNIT AND OUTDOOR UNIT This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Do not install the unit in a potentially explosive or flammable atmosphere. [. . . ] The initial setting remains active until the user changes it. The control panel can be used for multiple installations. Some functions may not be applicable to your unit. Simultaneously for 5 seconds to enter special setting mode. To enable YES or disable NO function, or set your desired day and time. Heating Priority (YES / NO) To choose the heat pump only use for Heating side during HEAT + TANK mode. Sterilization Continue Time To set timer to maintain heating temperature in order to complete the sterilization function (5minutes ~ 1hour). Using the control panel could set the temperature range for water outlet temperature and outdoor ambient temperature. When unit is ON, operation LED is lit and the actual temperature for water outlet and outdoor ambient are shown on the control panel display. - In this mode, the outdoor unit will provide heating capacity to the indoor unit. HEAT + TANK MODE - In this mode, the outdoor unit will provide heating capacity to the sanitary tank and indoor unit. - This operation is not used when the sanitary water tank is not installed. - In this mode, the outdoor unit will provide heating capacity to the sanitary tank. Press for 5 seconds to enter "SETTING" mode. After selecting the desired parameter, press enter the parameter. Repeat steps 2 to 5 to set other parameters. This operation reduces outdoor unit noise. In this condition, it may cause decrease in heating capacity. The backup heater provides extra heating capacity during cold outdoor temperature and only can operated at heat mode operation for indoor unit. The backup heater will automatically turn ON when the setting conditions is fulfilled. STATUS mode cannot be activated when the "SETTING" indicator is ON. Or wait 30 seconds to exit "SETTING" mode. [. . . ] Om te waarborgen dat de unit optimaal blijft presteren moeten in ieder jaargetijde de unit en de bedrading met regelmatige tussenpozen worden geïnspecteerd. These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products should not be mixed with general household waste. For proper treatment, recovery and recycling of old products, please take them to applicable collection points, in accordance with your national legislation and the Directives 2002/96/EC and 2006/66/EC. By disposing of these products correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. [. . . ]